1) PEDT/PSS
聚乙撑二氧噻吩/聚苯乙烯磺酸
2) PEDOT/PSS
聚(3,4-亚乙基二氧噻吩)/聚对苯乙烯磺酸
1.
The poly(3,4-ethylenedioxythiophene)/poly(styrenesulfonate)(PEDOT/PSS) has been synthesized by the method of chemical oxidation.
利用过硫酸铵为氧化剂通过化学氧化法合成了聚(3,4-亚乙基二氧噻吩)/聚对苯乙烯磺酸(PEDOT/PSS)。
3) poly(3,4-ethylenedioxythiophene)/poly(styrene-4-sulfonate) conducting polymer
聚二氧乙基噻吩/聚对苯乙烯磺酸导电高分子
4) Poly(3,4-ethylenedioxythiophene)
聚乙撑二氧噻吩
1.
Preparation and Characterization of Poly(3,4-ethylenedioxythiophene)/Carbon Nanotube Nanocomposites;
聚乙撑二氧噻吩/碳纳米管复合物的合成与表征
2.
The degradation of poly(3,4-ethylenedioxythiophene) (PEDOT) films at an anode in an aqueous solution has been systemically studied.
研究了聚乙撑二氧噻吩(PEDOT)膜在水溶液中的阳极降解过程。
3.
Poly(3,4-ethylenedioxythiophene) (PEDOT) was successfully synthesized in aqueous system by an acid doping method.
通过酸掺杂方法,成功地在水体系中合成出了聚乙撑二氧噻吩,并用傅立叶变换红外光谱证明了产物的分子结构。
5) Di(thienylene vinylene)
二聚(2,5-噻吩乙烯撑)
1.
Electronic Structures of Di(thienylene vinylene) of Ground and Excited States:Vinylene-and Ring-Substitution Effects
二聚(2,5-噻吩乙烯撑)基态和激发态的电子结构:桥基和芳环取代的影响
6) poly(3,4-ethylenedioxythiophene)
聚3,4-乙撑二氧噻吩
1.
Conducting polymer poly(3,4-ethylenedioxythiophene)(PEDOT) film electrodes were prepared by electrochemical polymerization from aqueous solution containing 0.
以水为溶剂,分别选用对甲苯磺酸钠、高氯酸锂、硫酸钠为支持电解质,用电化学法合成聚3,4-乙撑二氧噻吩(PEDOT)膜。
2.
Conductive polyacrylonitrile fiber modified by poly(3,4-ethylenedioxythiophene) was fabricated successfully by in-situ chemical oxidation polymerization.
采用原位化学氧化聚合方法在聚丙烯腈纤维表面生成聚3,4-乙撑二氧噻吩,制备得到纤维表面均匀覆盖聚3,4-乙撑二氧噻吩的改性导电纤维,其电导率约为1×10-3S/cm。
3.
Electrochemical Properties of Poly(3,4-ethylenedioxythiophene)/ Manganese Oxide Synthesized by Interfacial Polymerization
采用界面聚合法制备聚3,4-乙撑二氧噻吩/二氧化锰(PEDOT/MnO2)纳米复合物。
补充资料：聚苯撑氧
聚苯醚的化学名称聚2，6-二甲基-1,4-苯醚，是由2，6二甲酚在催化剂存在下聚合而得。相对密度1．06，玻璃化温度210℃，结晶熔融温度217℃，分解温度350 ℃，脆性温度-170℃，使用温度-l60～190℃。拉伸强度＞76MPa。有很高的机械强度，且随温度变化很小。刚硬性比尼龙、聚甲醛、聚碳酸酯高，而蠕变却最小。具有优良的耐酸、耐碱、耐沸水性。溶于二氯甲烷、二氯乙烷、氯仿、四氯化碳，不溶于乙醇、丙酮等。难燃，离火后自熄。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条