1) polyether-urethane
聚醚聚氨酯
1.
The characteristics of polyether-urethane networks containing four different functional agents were studies by stressstrain(ε～δ) and DMA test.
分别采用4种功能助剂通过拉伸实验和DMA试验对聚醚聚氨酯网络体系进行性能研究。
2.
The research concerns in the radiation effect ofγ-ray and electron beam on polyether-urethane.
本工作涉及聚醚聚氨酯材料经γ射线和电子束两种电离辐射辐照后的辐射效心研究。
3.
The radiation effect of γ-ray on polyether-urethane foam was studied.
讨论了经γ射线作用后聚醚聚氨酯(ETPU)泡沫塑料的辐射老化规律。
2) poly(ether urethane)
聚醚聚氨酯
1.
Ionic conductive property of solid electrolytes based on poly(ether urethane)/NaClO_4/hard-segment model compound;
聚醚聚氨酯/NaClO_4/硬段模型化合物的离子导电性能
2.
A poly(ether urethane) (PU) was synthesized via solution polymerization, which was mixed with LiClO4 and various plasticizers to generate a series of novel solid polymer electrolytes.
利用溶液聚合方法合成了聚醚聚氨酯,并以聚氨酯、高氯酸锂和增塑剂为组分,制备了一系列新型聚合物固体电解质。
3.
The linear poly(ether urethane)(PEG-PU) was synthesized by solution polymerization and a series of solid polymer electrolytes based on the complexes of poly(ether urethane) with sodium perchlorate (NaClO 4) were prepared.
采用溶液聚合的方法合成了线型聚醚聚氨酯 ( PEG-PU) ,以其作为基体 ,与高氯酸钠 ( Na Cl O4)复合制得了一系列新型的聚合物固体电解质 。
3) polyether polyurethane
聚醚聚氨酯
1.
The results showed that LDA had good compatibility with polyether polyurethane elastomer,improved its physical and mechanical properties greatly;but APP's compatibility with the elastomer was worse compared with LDA.
以聚氧化丙烯二醇 (N2 2 0 )、甲苯二异氰酸酯、一缩二乙二醇等为主要原料 ,以联二脲 (LDA)、聚磷酸铵(APP)作为阻燃剂 ,研制了聚醚聚氨酯弹性体。
2.
An oligo polyether sulfate(SPEO) was prepared from polyethylene oxide and HClSO 3 and a series of solid polymer electorlytes, complex of oligo polyether sulfate with polyether polyurethane, were prepared using polydioxolane as a plasticizer.
以聚二氧戊环为增塑剂 ,通过低聚醚硫酸盐与聚醚聚氨酯的混合 ,制备了一系列新型的聚醚聚氨酯 /低聚醚硫酸盐 ( PU /SPEO)电解质 。
4) polyether-urethane
聚醚氨酯
1.
Evaluation of small-angle X-ray scattering of polyether-urethane;
聚醚氨酯的SAXS研究
2.
A set of polyether-urethane block copolymers were prepared that poly(tetramethylene oxide)PTMEG was regarded as soft segment and 4,4'-methylenebis(phenyl isocyanate)(MDI) was regarded as hard segment in this article.
以聚四氢呋喃二醇 (PTMEG)为软段 ,以 4 ,4’ 二苯基甲烷二异氰酸酯 (MDI)和间苯二胺为硬段 ,合成了一系列聚醚氨酯嵌段共聚物。
3.
Silicon-containing foamed polyether-urethane was prepared by toluenediisocyanate, polyols, foamer dichloromethane and chain extender dihydroxyl tetracoordinate silicon.
以SiO2 为原料 ,通过非碳热法合成出双羟基四配位硅化合物 ;然后以此为扩链剂 ,以二氯甲烷为发泡剂 ,与甲苯二异氰酸酯、聚醚多元醇反应制成含硅发泡聚醚氨酯。
5) polyether urethane
聚醚氨酯
1.
The investigation on polyether urethane and epoxydiacrylates resins simultaneous interpenetrating polymer networks (Ⅰ);
聚醚氨酯环氧树脂同时互穿网络的研究(Ⅰ)
2.
The investigation on polyether urethane and epoxydiacrylates resins simultaneous interpenetrating networks(Ⅱ);
聚醚氨酯环氧树脂同时互穿网络的研究 (Ⅱ )
3.
The preparations of interpenetrating polymer networks (IPNs) based on polyether urethane and epoxydiacrylates resin by simultaneous polymerization technique was investigated.
通过改变聚醚氨酯和环氧丙烯酸酯树脂组分比 ,合成了不同组成的同时互穿网络聚合物 (SINs) ,采用红外光谱 ,扫描电镜和动态热力学分析等测试方法 ,研究了 SINs材料的组分间分子混合和形态结构 ,探讨了材料的组分与力学及热学性能的关系。
6) polyurethane
[英][,pɔli'jʊərəθeɪn] [美]['pɑlɪ'jurə'θen]
聚醚氨酯
1.
In this paper, the interpenetrating polymer network (IPN) based on UV\|curing polyurethane (PU) and epoxy (EP) was studied.
本文以光固化型的聚醚氨酯 (PU)与环氧树脂 (EP)为体系 ,由不同的组成比制备了一系列 PU/EP的 IPN材料 ,经力学性能测试 ,均显正协同效应 ,且协同效应的大小与聚合物网络的互穿程度有关 。
2.
This paper studied the interpenetrating polymer networks based on UV curing polyurethane(PU) and epoxy(EP) with different preparating methods——simultaneous and sequential.
分别采用同步互穿和顺序互穿的方法制备了光固化型的聚醚氨酯（ＰＵ）与环氧树脂（ＥＰ）的互穿网络聚合物（ＩＰＮ）。
补充资料：聚醚聚氨酯漆
分子式：
CAS号：
性质： 由聚醚和多异氰酸酯按比例配制而成的一种双组分涂料。漆膜具有优良的耐碱性、耐寒性和柔韧性，但耐候性较差。主要用作室内的抗化学腐蚀漆、地板漆等。
CAS号：
性质： 由聚醚和多异氰酸酯按比例配制而成的一种双组分涂料。漆膜具有优良的耐碱性、耐寒性和柔韧性，但耐候性较差。主要用作室内的抗化学腐蚀漆、地板漆等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条