1) antimony-doped tin oxide
锑掺杂氧化锡
1.
The Preparation and Research Progress of Nanometer Antimony-doped Tin Oxide
锑掺杂氧化锡纳米粉体的制备及其研究进展
2.
Conductive powder (Sb–SnO2/BaSO4) of a barite matrix coated with antimony-doped tin oxide was successfully prepared by a chemical co-precipitation technique.
探讨了锑掺杂氧化锡的缺陷与能级效应,确定了导电粉末中掺杂效应的缺陷反应。
3.
SnCl4·5H2O and SbCl3 were used as the initial materials to prepare antimony-doped tin oxide(ATO) nanoparticles by sol–gel method combined with the supercritical fluid drying technique.
以无机盐SnCl4·5H2O和SbCl3为初始原料,以乙醇作为溶剂,采用溶胶-凝胶法结合超临界流体干燥(supercritical fluid drying,SCFD)技术制备了纳米锑掺杂氧化锡(antimony doped tin oxide,ATO)粉体。
2) antimony doped tin oxide
锑掺杂二氧化锡
1.
The conducting mechanism and preparation status of nano-sized antimony doped tin oxide (ATO) are introducted.
从二氧化锡的应用出发,总结了锑掺杂二氧化锡的导电机理和该材料湿相制备方法的研究现状。
2.
Polyethylene terephathalate(PET)-polyether ester(PEE)/antimony doped tin oxide(ATO) composites(PET-PEE/ATO) were prepared by means of three-step co-polycondensation.
采用三步共缩聚法制得聚对苯二甲酸乙二酯-聚醚酯/锑掺杂二氧化锡复合聚酯。
3.
The characteristics, conductive mechanism, status of preparation, exisiting problems of antimony doped tin oxide(ATO) are introducted.
介绍了锑掺杂二氧化锡(ATO)的特点、导电机理、制备方法研究现状及目前存在的问题。
3) Antimony doped Tin Oxid
锑掺杂氧化锡(ATO)
4) antimony-doped tin oxide
掺锑氧化锡
1.
Effects of calcination temperature on antimony-doped tin oxide powders
煅烧温度对掺锑氧化锡粉体性能的影响
2.
The BET,XRD and TEM measurements of the precursor power and the calcinated antimony-doped tin oxide powder were carried out.
用BET、XRD和TEM等方法对前驱体和掺锑氧化锡纳米粉体进行表征。
3.
Conductive antimony-doped tin oxide(ATO) ultra-fine powder is prepared by hydrolysis of alkoxides, using SnCl4·5H2O and SbCl3 as raw materials.
以SnCl4·5H2O和SbCl3为原料,用醇盐水解法制备了纳米掺锑氧化锡(ATO)导电粉体。
5) Sb-doped tin oxide
掺锑氧化锡
1.
Result showed that the obtained Sb-doped tin oxide nanopowders possessed high specific surface area.
结果表明,采用乙醇超临界流体干燥法可得到高比表面积的掺锑氧化锡纳米粉体。
2.
Sb-doped tin oxide nanopowders with tetragonal rutile structure were obtained after calcination of the dried Sb-doped tin hydroxide.
5H2O和SbCl3乙醇溶液为原料,采用离子交换除氯水解法得到无氯离子的掺锑氢氧化锡胶体沉淀,以正丁醇作脱水剂对胶体进行共沸干燥处理,所得的掺锑氢氧化锡干微粉经热处理后得到了四方形金红石结构的掺锑氧化锡纳米粉末。
3.
Sb-doped tin oxide nanopowders have been synthesized by ion-exchange for removal of chlorine hydrolysis method and azeotropic distillation drying with n-Butanol method,using ethanol solution containing SnCl4?5H2O and SbCl3 as raw materials.
5H2O和SbCl3乙醇溶液为原料,采用离子交换除氯水解法及正丁醇共沸蒸馏干燥法制备得到了掺锑氧化锡纳米粉末,用FT-IR、XRD和TEM等方法对粉体进行了表征。
6) antimony-doped tin oxide film
锑掺杂氧化锡薄膜
补充资料：一氧化锡
又名氧化亚锡，化学式SnO，分子量134.7。暗灰或棕黑色粉末。在空气中稳定，加热时转化为氧化锡(二氧化锡)，不溶于水和醇。溶于盐酸或稀硫酸生成亚锡盐，溶于浓的强碱溶液生成亚锡酸盐。有还原性。用作还原剂，制备亚锡盐，还用于电镀和玻璃工业。由亚锡盐溶液跟氢氧化钠溶液反应生成氢氧化亚锡Sn(OH)2，再加热分解生成氧化亚锡。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条