1) Ti pre-alloying
钛预合金化
1.
The electrolytic low titanium Al-based alloy of Ti pre-alloying was used as raw material for producing the eutectic Al-Si ZL108Ti alloy.
以钛预合金化电解低钛铝合金为母材配制共晶铝硅合金ZL108Ti,研究了其组织细化的条件。
2) Chemical milling technology for titanium alloy
钛合金化铣
3) titanium micro-alloying
钛微合金化
1.
Development of titanium micro-alloying in high strength low alloy steel;
低合金高强度钢钛微合金化进展
4) prealloying
预合金化
5) Nb-Ti micro-alloyed steel
铌钛微合金化钢
6) in-situ titanium alloying
原位钛合金化
1.
The microstructure and mechanical properties of in-situ titanium alloying A356 alloys with different titanium contents (0.
研究了不同含钛量(分别为0 07%Ti、0 13%Ti、0 19%Ti)的原位钛合金化A356合金的微观组织和力学性能,并与相应含钛量熔配加钛A356合金进行了对比,发现原位钛合金化A356合金的二次枝晶臂间距小于熔配加钛合金,随着钛含量增加二次枝晶臂减小且趋势相同。
2.
In this study, the microstructure and mechanical properties of two kinds of in-situ titanium alloying motorcycle wheels, unmodified and modified with Sr respectively, were investigated and compared with that of tradition motorcycle wheels produced by tradition A356 alloy.
研究了变质处理和未变质处理原位钛合金化摩托车车轮的微观组织和力学性能 ,并与传统A3 5 6合金制造的车轮的微观组织和力学性能进行了对比 ,发现原位钛合金化A3 5 6合金车轮的组织均较传统A3 5 6合金的细小 ,不管是否经过变质处理 ,三种车轮的硅颗粒均得到明显的纤维化 ,但未变质处理的A3 5 6合金车轮的硅颗粒稍粗。
补充资料：机械合金化高温合金管材和方型材
机械合金化高温合金管材和方型材
机械舍金化高温合金管材和方型材
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条