1) silica sol precursor
硅溶胶前体
2) precursory sol
前驱体溶胶
1.
By using AlCl_3·6H_2O and MgCl_2·6H_2O as starting materials, precursory sol is prepared, then aluminum magnesium hydroxide nanometer powder is prepared through SCDF.
以结晶氯化铝(AlCl3·6H2O)、结晶氯化镁(MgCl2·6H2O)为主要原料制备前驱体溶胶,然后采用超临界流体干燥技术(SCDF)制备纳米氢氧化铝镁超细粉体。
4) silica sol
胶体二氧化硅溶胶
5) silica sol
硅溶胶
1.
Behavior of silica sol during the anodizing process of magnesium alloy;
硅溶胶在镁合金阳极氧化反应中的成膜作用
2.
Determination of Na Content in Silica Sol by ICP-AES;
ICP-AES测定硅溶胶中Na元素的分析方法研究
3.
Research progress of preparation and application of silica sol;
硅溶胶制备与应用研究进展
6) silicon sol
硅溶胶
1.
The result showed that hardness of the composites rose with increasing of the silicon sol dosage;when the dosage of silicon sol is greater than 10%(mass fraction),it has weak effects on the material hardness,and bad effects on other mechanical properties of t.
结果表明:随着硅溶胶量的不断增大,材料硬度随之增大,当硅溶胶加入量大于10%(质量分数)时,对材料硬度的影响较小,且不利于材料的其他力学性能。
2.
With tetraethyl ortho-silicate (TEOS) as main material and through the polymerization-sol process, silicon sol is obtained and is compounded with styrene-acrylic latex to give complex binder, then the silicon sol and styrene-acrylic complex road-mark coatings.
采用正硅酸乙酯(TEOS)为主要原料,以聚合溶胶法制备硅溶胶,制得的硅溶胶与苯丙乳液冷拼复配得到复合基料,再以该基料制得硅溶胶—苯丙复合路标涂料。
3.
The preparation of nano-silica by chem-deposit method is carried out by using basic silicon sol and inorganic acid as materials.
以碱性硅溶胶和无机酸为原料,水和甲醇为反应介质,加入适宜的分散剂,反应体系在适宜的反应温度和pH值下反应一定时间,经过真空脱水干燥和超细筛网筛分得到稳定的纳米二氧化硅粉体。
补充资料：氮化硅纤维增强体(见氮化硅纤维)
氮化硅纤维增强体(见氮化硅纤维)
silicon nitride fibres reinforcements
夔薰黔慧燃泳
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条