1) thermal wave
热波
1.
An application of the theory of thermal wave: dynamic measure of the heat conductivity of a good thermal conductor;
热波理论的应用——良导热体热导率的动态法测量
2.
The thermal wave distribution in the Ni-Ce-Cu-L i/Al 2O 3 catalyst bed for the reaction of CH 4, CO 2 and O 2 to syngas was studied by a micro fixed-bed reactor.
采用微型固定床反应装置 ,研究了甲烷、二氧化碳和氧气制氧化重整合成气时Ni Ce Cu Li/Al2 O3催化剂床层的热波分布 ,考察了炉温和进料配比对催化剂床层热波分布的影响 。
3.
The thermal wave in a fixed bed reactor for catalytic partial oxidation of methane (POM) to syngas was investigated under various conditions, such as furnace temperature, space velocity, n (CH 4)/ n (O 2) and diluted/undiluted catalyst beds.
研究了 甲烷部 分氧化（ Ｐ Ｏ Ｍ） 反 应 在 固定 床 反应 器 中 轴向 的 温度 场 分 布（ 或 热波 分 布） 。
2) heat wave
热波
1.
The propagation of heat waves and the influencing factors in tank fires of heavy oils;
重质油罐火灾热波传播及影响因素研究
2.
It is demonstrated that negative entropy flow exists in shock wave and shock wave is a kind of heat wave which transfers heat with traveling wave velocity.
证明了激波是一种负熵流波,是依靠激波波速输运热流的热波。
3.
Shock wave images were recorded by optical streak camera, heat wave and rarefaction wave images were measured using X ray streak camera.
在“星光Ⅱ”上 ,使用三倍频激光打三种厚度 (6 ,10和 2 0 μm)的铝介质平面靶 ,采用光学条纹相机记录冲击波图像 ,对热波和稀疏波进行测量 ,同时开展冲击波、热波和稀疏波三波相互作用规律的初步研究 ,采取多种措施成功地观测到冲击波在前、辐射热波在后、稀疏波更晚的三波物理图
3) microwave heating
微波加热
1.
Preparation of lowly-hydrated zinc borate by microwave heating;
微波加热制备低水硼酸锌
2.
Preparation of high specific surface area activated carbon from tobacco stem with potassium carbonate activation by microwave heating;
微波加热碳酸钾法制备烟杆基高比表面积活性炭
3.
Mechanisms and significance of microfractures generated by microwave heating in sandstone reservoirs;
砂岩储集层微波加热产生微裂缝的机理及意义
4) Infrared thermal wave
红外热波
1.
Measurement of defect depth by infrared thermal wave nondestructive evaluation based on pulsed phase;
基于脉冲位相的红外热波无损检测法测量缺陷深度
2.
FFT-based Image Mosaicing of Infrared Thermal Wave Images;
基于傅里叶变换的红外热波图像拼接
3.
To satisfy the increased requirements in quantitative defect depth measurements, pulse phase thermograph is proposed based on the property of pulsed infrared thermal wave nondestructive testing.
针对目前缺陷深度定量无损检测的需求,利用脉冲式红外热波无损检测脉冲激励的特点,对平底洞试件进行脉冲式红外检测实验,在VC++中通过傅里叶变换处理得到位相热图序列,分析不同深度缺陷的盲频,进而得到缺陷深度。
5) microwave-hydrothermal
微波水热
1.
4TiO3(BST) nanopowders are successfully synthesized by microwave-hydrothermal (MH) method.
采用微波水热法成功合成了钛酸锶钡(Ba0。
2.
5)TiO_3(BST) nanopowders were prepared by microwave-hydrothermal method.
采用微波水热法合成了纳米晶钛酸锶钡(Ba0。
6) thermal shock wave
热激波
1.
Attenuation of thermal shock waves induced by electron beam irradiation in C/PH composite;
新型碳酚醛中的辐射热激波衰减特性
2.
The behaviors of thermal shock wave in the three-dimensional braided composite radiated by pulsed electron beam were experimentally studied on 'Flash II' accelerator with a guard-ring piezoelectric quartz measuring technique.
在“闪光二号”脉冲电子束加速器上,采用自行研制的保护环式石英压电传感器,对三维多向碳纤维编织复合材料的热激波传播特性开展了实验研究。
3.
Propagation and attenuation behavior of thermal shock wave in 3 dimensional (3 D)braided composites radiated by pulsed electron beam were studied experimentally on “FLASH II”accelerator.
采用保护环式石英压电测量技术 ,在“闪光 2号”脉冲电子束加速器上 ,进行了三维编织复合材料的热激波传播衰减特性实验研究。
补充资料：埃波拉出血热病毒
见马尔堡病病毒。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条