1) Ti-alloy drilling
钛合金钻削
1.
Mainly preseating the function characteristies of Ti-alloy,and the main factors that affect Ti-alloy drilling and tapping processing are analyzed.
主要叙述了钛合金的性能特点,同时分析了影响钛合金钻削和攻丝加工的主要因素,并提出改进钛合金钻削和攻丝加工的工艺参数和相应措施。
3) Brief Introduction about Turning on Titanium Alloy
钛合金的车削加工
4) titanium and its alloys
钛和钛合金
1.
The barriers were prospected to be used in titanium and its alloys as protective coatings.
概述了防止氢和氢同位素渗透壁垒层的研究进展,展望了这些壁垒层在钛和钛合金基体上的应用前景。
5) titanium and its alloys
钛及钛合金
1.
A simultaneous determination of oxygen and hydrogen in titanium and its alloys on infrared absorption has been described,and the optimal conditions have been obtained.
叙述了用红外吸收法对钛及钛合金中氧和氢联合测定的方法,取得了测定的最佳条件。
2.
Anodizing coloring mechanism of titanium and its alloys was analyzed to make sure the relationship of fiun thickness and coloring power source, so that the technological method and current design parameters were deduced to keep the color consistence of bath production, which provided an available method for coloring of titanium and its alloys.
分析了钛及钛合金阳极氧化着色机理及色膜厚度与氧化着色电源之间的关系,得出了保证成批量着色颜色一致性的工艺方法及电流设计参数,为钛及钛合金着色的应用提供了一种可用的方法。
3.
However, the production and utilization of titanium and its alloys are limited for their high chemical activity at molten state.
钛及钛合金具有密度小、强度高、耐腐蚀等一系列优点,在航空航天、国防军事、民用轻工等领域均有广泛应用前景。
6) Ti and its alloy
钛及钛合金
1.
The determination of Zr, Ru, Pd, Hf, Cu, Y, V, Mo, Nb, Al, Co, Ni, Ta, Bi, Sn, Cr and Mn in Ti and its alloys have been studied using an atomic emisson spectrum spectroscopy.
采用发射光谱分析技术,研究了钛及钛合金中Zr,Ru,Pd,Hf,Cu,Y,V,Mo,Nb,Al,Co,Ni,Ta,Bi,Sn,Cr,Mn的光谱测定方法。
补充资料：Ti-55高温钛合金显微组织
Ti-55高温钛合金显微组织
丫‘“合‘{丫:黔
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条