说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 介质混合法则
1)  dielectric mixing laws
介质混合法则
1.
The effect of ceramic fine power content on dielectric propert as well as the dependence of dieletric properties were investigated and dielectric constant were also predicted using dielectric mixing laws.
研究了陶瓷微粉含量对其介电性能的影响以及介电性能的频率和温度特性 ,并用介质混合法则对其介电常数进行拟合分析。
2)  mixed media
混合介质
3)  mixing rule
混合法则
1.
The transverse stress of clad material was analyzed with the mixing rule,and the results show that the yield stress,tensile stress and the thickness ratio obey exponent function.
针对半固态连接制备的不锈钢-铝合金复层材料,对不同相对厚度比的复层材料进行拉伸试验,将试验数据与混合法则相比较,并建立了屈服点、抗拉强度与相对厚度比之间的关系模型。
2.
Some successful vapor-liquid equilibrium(VLE) mixing rules based on excess free energy models proposed in recent years combines the advantages owned partially by equations of state and activity coefficient models to obtain the better prediction for nonpolar and polar systems.
绝大多数状态方程是结合简单的vanderWaals混合法则来进行VLE数据关联的 。
3.
The mixing rule of MH epuation Based on G ̄E model is proposed,by which the fluid phase equilib-rium calculation is carried out.
提出了MH方程基于G ̄E模型的混合法则,并用于流体相平衡计算。
4)  dielectric mixture
介质混合体
1.
The dipole approximation seriously compromises the accuracy in the calculations of the local electrical field strengths for a dielectric mixture with a great dielectric mismatch when the particles approach closely.
对于颗粒相互靠近、两相介电系数比较大的介质混合体来说,采用偶极子模型(Dipoleapproximation)计算局部场强将会引起很大误差。
5)  Au-Gd mixture
AuGd混合介质
6)  ENDIF
介质增强法则
1.
In this thesis, addressed the breakdown voltage and self-heat problems of SOI, under the guidance of ENDIF (Enhanced Dielectric layer Field), using MEDICI simulation and optimization of the three new structures of SOI high voltage devices.
本文围绕SOI器件的击穿特性与热特性问题,在介质增强法则ENDIF(Enhanced Dielectric layer Field)指导下,利用二维数值仿真软件MEDICI仿真优化了三种SOI高压器件新结构,并分析了此三种结构的纵向耐压机理和散热机理。
补充资料:复合材料混合法则


复合材料混合法则
rule of mixture

  复合材料混合法则rule of mixture从复合材料各组分性能分量计算复合材料相应性能的方法。为了估算单向纤维复合材料(或单层)的性能,人们常常借助于组分材料的性能、组分材料的几何排列和相应的体积含量,通过分析求解。这种分析计算常常很复杂。因而,要求提出一些简单、近似的方法。混合法则就是从组分性能估算复合材料性能的一种简单方法。估算结果和试验结果比较一致。 使用混合法则估算复合材料性能时,应满足下列前题:①复合材料宏观上是均质的,不存在内应力;②各组分材料是均质的各向同性(或正交异性)及线弹性;③各组分材料之间粘结牢固,无孔隙。 用于计算连续纤维复合材料纵向弹性模量EL的棍合法则为 EL~Ef歼十百nl(1一科)式中Ef、百n刀分别为纤维、基体的纵向弹性模量,铸为纤维的体积分数。 用于计算连续纤维或不连续纤维复合材料主泊松比姚T的混合法则为 夕LT=战Tf环+夕LTm(1一环)式中姚Tf和战、分别为纤维和基体的主泊松比,认为纤维的体积分数。 (张晓明)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条