1) powder size
原料粒度
1.
Effect of sintering temperature and powder sizeon properties of aluminium titanate;
合成温度和原料粒度对钛酸铝性能的影响
2) Granularity of the raw material
原料粉末粒度
3) particle size
原料粒径
1.
Perovskite-type layered lanthanum titanate powders with different particle size were fabricated by solid-state reaction of K 2CO 3, La(NO 3) 3 and TiO 2.
结果表明 :降低原料粒径 ,固相反应速率加快、温度降低 ,有利于合成小尺寸、比表面积大 (可达 11。
2.
The influence of the particle size of starting material TiO_2 on the velocity of solid state reaction and the morphology of the resulting products were studied.
结果表明:减小原料粒径,反应温度降低、速率加快;有利于合成小尺寸、大比表面积(可达11。
4) Primary crystal size
原晶粒度
5) original size
原粒度
1.
The paper introduces an original size measurement of ferric oxide desulfurizer,and does an experiment compare to the small size measurement.
介绍了一种氧化铁脱硫剂硫容的原粒度测定方法 ,并与小粒度测定方法作了对比实验。
6) abrasive size
磨料粒度
1.
The change of abrasion resistant of epoxy adhesive coating in different abrasive sizes and different concentrations are studied when it was eroding.
研究了环氧胶粘涂层在不同的磨料粒度和浆体浓度下冲蚀磨损时耐磨性能的变化,对比了T-31、低分子聚酰胺两种固化剂和粉煤灰、有机蒙脱土两种填料对环氧胶粘涂层性能的影响,探讨了纳米粒子在环氧胶粘涂层中的作用,推荐了纳米环氧胶粘涂层的最佳配方。
补充资料：CLY-1型超声波在线粒度分析仪
CLY-1型超声波在线粒度分析仪
黔CLY一l型超声波在线粒度分析仪
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条