1) pressure die
压力模
1.
To introduce the use of assembly pressure die in Al cladding steel wire drawing Joint ways between pressure casing pipe and pressure die are discussed The results show that the productivity,rate of useful product and quality of product can be raised,the auxiliary materials consume can be decreased by improving pressure casing pip
介绍组合压力模在铝包钢丝拉拔中的使用 ,讨论压力套管与压力模的结合方式 ,结果显示通过改进压力套管可提高生产效率、成材率、产品质量 ,降低辅料消
2.
Experimental study at abroad show that because of lubricating under pressure state when drawing steel wire with pressure dies,the friction coefficient reduces 48% and the drawing force decreases about 20% compared with drawing with traditional dies as using same lubricantThe mechanical properties of steel wire drawn by pressure dies are improved obviousl
国外实验研究表明：使用压力模进行钢丝拉拔时，由于润滑剂在压力状态下润滑，因而与传统拉丝模拉拔相比，在使用同种润滑剂时摩擦因数减小４８％，拉拔应力降低２０％左右。
2) molding pressure
模压压力
1.
Effect of the molding pressure on properties of pitch-based carbon composites reinforced with granular cokes
模压压力对焦炭颗粒增强沥青基炭复合材料性能的影响(英文)
2.
The effects of molding pressures on the mechanical properties of 2D-Cf/SiC composites were investigated.
以聚碳硅烷、SiC微粉为原料,二维碳纤维织物为增强体,采用先驱体转化法制备了2D-Cf/SiC复合材料,考察了模压压力对2D-Cf/SiC复合材料常温力学性能的影响。
3.
The effect of molding pressure on packing density of coke powders has been studied in a hydraulic press machine with advanced data-collected system.
采用液压机和先进的数据采集系统对模压压力影响焦炭粉体的堆积密度进行了研究。
3) Filling Cavity Pressure
充模压力
1.
Experimental Research on Effect of Pulsatile Injection Pressure on Filling Cavity Pressure and Filling Time;
脉动注射压力影响充模压力及充模时间的实验研究
4) ejecting pressure
脱模压力
5) Roller die pressure
辊模压力
补充资料：模制压力
分子式：
CAS号：
性质：又称合模压力。硫化过程中为了保持模具闭合及胶料充满型腔而施加到模具上的压力。
CAS号：
性质：又称合模压力。硫化过程中为了保持模具闭合及胶料充满型腔而施加到模具上的压力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条