1) cold heading steel wire
冷顶锻钢丝
1.
To expound the trial production process of new material ML18Al cold heading steel wire for making tapping by self screw The effects of wide drawing,fine drawing and spheroidization process on the mechanical properties of steel wire are inquired The quality of trial products can satisfy consumers′ need
论述用于制造自攻螺钉的新材料ML18Al冷顶锻钢丝试制的全过程,探讨粗拉、精拉及球化处理工艺对钢丝力学性能的影响。
2.
To systematically research the feasibility of using SWRM10 wire rod as a substitute for SWRCH10A to produce small specification cold heading steel wire for screw according to the requirements of market.
根据市场需求 ,对用SWRM1 0替代SWRCH1 0A线材生产小规格螺钉用冷顶锻钢丝的可行性进行系统研究 ,给出生产工艺流程 :60 %以上总压缩率的半成品拉拔 +再结晶退火 +30 %以下总压缩率的成品拉拔。
2) cold heading
冷顶锻
1.
To make tower test,cold heading test on 22mmQ235-B and low times microstructure inspection on rolling steel.
对Φ22 mm Q235-B圆钢进行了塔形试验、冷顶锻试验和轧制过程坯料低倍金相检验。
2.
The spheroidization of cold heading low carbon steel wire is a key procedure in production.
冷顶锻低碳钢丝的球化退火是其生产中的关键性工序 ,它可以改善钢丝的力学性能 ,显著提高钢丝的冷顶锻工艺性。
3) Cold Forging Steel
冷锻钢
4) cold forging test
冷顶锻试验
5) forge wire rope
锻打钢丝绳
1.
In comparison with facial contact wire rope,the forge wire rope has such advantages as wear-resisting,longer service life,higher broken force,less lay remain stress,so the forge wire rope replacing facial contact wire rope is feasible in theory.
锻打钢丝绳与面接触钢丝绳相比 ,具有耐磨损、寿命长、破断拉力高、捻制残余应力小等优点 ,因此锻打钢丝绳替代面接触钢丝绳在理论上是可行的。
6) forged cold roll
锻钢冷轧辊
1.
The trial is done for wearability and resistance to heat shocks of forged cold roll of Cr3, Cr5 series, and the latter shows better in both the properties.
耐磨性和抗热冲击性是锻钢冷轧辊的重要使用性能指标,对邢台机械轧辊(集团)有限公司生产的Cr3系列、Cr5锻钢冷轧辊的耐磨性和抗热冲击性进行了试验研究,结果表明Cr5锻钢冷轧辊比Cr3系列具有更高的耐磨性和抗热冲击性。
补充资料：α型钛合金热锻缓冷组织
α型钛合金热锻缓冷组织
719
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条