1) total Ti content
总钛含量
2) Ti content
钛含量
1.
Effects of Ti content on austenite coarsening temperature in AH36 steel were studied with Gleeble 1500 thermal simulator.
结果表明 :钛含量增加 ,钢的粗化温度提高 ,该钢合理的加热温度范围为12 0 0～ 12 5 0℃。
2.
Effects of chemical composition and rolling schedule on mechanical properties of 10 Ti steel have been studied in order to optimize Ti content and stabilize mechanical properties by using mechanical test, phase-analysis, SEM and TEM etc.
为了节约钢中钛含量,稳定力学性能,本文采用力学性能;相分析;扫描电镜、透射电镜等试验,研究了成分、轧制工艺对10Ti钢力学性能的影响机制。
3) Titanium Content
钛含量
1.
Effect of Titanium Content on Mechanical Properties of Hot Rolled Plate of Nb-Ti Microalloying Q345A Steel;
钛含量对Nb-Ti微合金化Q345A钢热轧板力学性能的影响
2.
Effect of titanium alloying manner and titanium content on microstructure and mechanical properties of A356 alloys;
加钛方式与钛含量对A356合金组织和性能的影响
4) concentrations of tilanium and iron
钛铁含量
5) effective titanium content
有效钛含量
1.
The influences of six kinds of conditioning heat treatments and different effective titanium contents on the behavior of austenite grain coarsening were studied.
研究了6种预先热处理工艺及有效钛含量对18CrMmVB钢奥氏体晶粒长大行为的影响。
6) total sugar content
总糖含量
1.
At the same time,the UV spectrums as well as the reducing sugar and the total sugar content of the samples were determined before and after 105℃ dr.
3-2003《食品中水分的测定》中规定的方法,并参考中国药典附录中的相关规定,分别采用直接干燥法、减压干燥法、蒸馏法测定了样品的水分含量,同时测定了样品在105℃烘干前后的紫外光谱以及还原糖和总糖含量。
2.
Mothods The total sugar content was taken as the study indicators of digestion rate.
为探讨杜仲粕壳酶解液中总糖含量的测定方法的可行性,将其总糖含量作为酶解率的考察指标,在相同酶解条件下,同一用量的不同种类酶和不同用量的同一种酶分别对杜仲粕壳酶解,采用蒽酮比色法,以供试品空白为参比测定酶解液中总糖的含量。
3.
A short-wave near infrared spectroscopic technique combined with partial least squares(PLS) method was developed for the determination of total sugar content in red wine based on the establishment of the optimal mathematic calibration models.
采用短波近红外光谱技术结合偏最小二乘法(PLS),建立了葡萄酒中总糖含量的定量分析数学模型,讨论了光谱预处理方法和主成分数对PLS模型预报精度的影响。
补充资料：总氯含量测定
分子式：
CAS号：
性质：氯丁橡胶中总氯含量的测定方法常用的有两种：氧瓶燃烧法和容量法。氧瓶燃烧法是将试样在铂丝为催化剂条件下燃烧，将氯转化为钾盐，再以硝酸汞标准溶液滴定。容量法是将试样与碳酸钠-硝酸钾混合物于350～400℃下熔融分解为氯化氢，同时转化成氯化物，再以硝酸银容量法测定。这些测定方法同时亦可以用于测定氯化丁基橡胶和氯磺化聚乙烯中氯含量。
CAS号：
性质：氯丁橡胶中总氯含量的测定方法常用的有两种：氧瓶燃烧法和容量法。氧瓶燃烧法是将试样在铂丝为催化剂条件下燃烧，将氯转化为钾盐，再以硝酸汞标准溶液滴定。容量法是将试样与碳酸钠-硝酸钾混合物于350～400℃下熔融分解为氯化氢，同时转化成氯化物，再以硝酸银容量法测定。这些测定方法同时亦可以用于测定氯化丁基橡胶和氯磺化聚乙烯中氯含量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条