1) blowing strength
送风强度
2) strengthened air supply
强化送风
1.
With a project example, presents some methods including adopting local strengthened air supply to reduce the contamination level of the key area, adopting roughing filter and medium efficiency filter to handle the fresh air and adopting constant air volume dampers to control positive pressure in operating rooms.
结合工程实例 ,介绍了手术室空调设计新思路 :采用局部强化送风降低手术室关键区域的空气污染度 ;采用粗、中效两级过滤器处理新风 ;采用定风量阀控制正压。
3) forced air supply
强制送风
4) forced draft oven
强制送风炉
5) blast system
送风制度
1.
Practice of blast system adjustment in No.8 blast furnace of Xuanhua I & S Co.;
宣钢8~#高炉送风制度调整实践
6) blast temperature
送风温度
1.
Representative instrument adjusting loop——the composition and characteristic of combustion control;blast temperature control;blasting humidity control are emphasized.
着重介绍了热风炉典型仪表控制回路——燃烧控制、送风温度控制、送风湿度控制的构成和特点。
2.
When no high heat value gas input,blast temperature of HBS is 1250～1300℃.
没有高发热量煤气混入时,热风炉送风温度为1250～1300℃；有高发热晕煤气混入时,热风炉送风温度为1350～1400℃。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条