1) simple shear
单剪
1.
A series of numerical simulations of true triaxial,simple shear and hollow cylindrical torsional shear tests is performed.
通过对真三轴试验、单剪试验和空心圆柱试验进行数值模拟,表明修正后的形状函数能够更好地描述砂土在真三维状态下的变形特性,更重要的是非共轴理论的引入使得模型能够合理预测主应力轴旋转过程中主应力和主应变率的方向变化规律。
2) single shear
单剪,单剪力
3) simple shear
简单剪切
1.
The variation of tearing energy with crack size was calculated for the bonded crack of simple shear rubber using non-linear finite element analysis.
通过有限元分析方法模拟简单剪切橡胶件粘结处裂纹扩展时撕裂能与裂纹尺寸的关系。
2.
The width of a shear band formed in saturated soils under simple shear and combined stress statehas been investigated.
主要对饱和上在简单剪切和耦合载荷下的剪切带宽进行了理论分忻。
3.
The tectonic association is explained by the simple shear, and the two areas of simple shear and three other tectonic areas in China and the nearby sea area are divided.
采用简单剪切对中国活动构造组合进行解译，提出简单剪切是主要变形机制，着重对简单剪切依据进行了论述，对简单剪切与老构造的关系作了初步讨论，提出需要继续探讨的主要问题。
4) veneer cutting
单板剪裁
1.
Application of fuzzy control in veneer cutting;
模糊控制在木材单板剪裁中的应用
5) simple shear test
单剪试验
1.
Large-scale simple shear test on mechanical properties of interface between concrete face and gravel underlayer;
砾石垫层—混凝土接触面力学特性单剪试验研究
2.
Mechanical characteristics of the soil-structure interface in response to simple shear tests under constant stress increment ratio paths;
土与结构接触面等应力增量比路径单剪试验力学特征分析
3.
By using a special two dimensional simple shear test apparatus with rigid lateral platens, simple shear tests are carried out on an assembly of aluminum rods, one of which is then simulated by distinct element method (DEM).
用铝棒堆积体作为二维粒状体的模型材料进行单剪试验 ,然后对其用离散单元法进行数值模拟 ,对于宏观应力应变关系 ,两者结果基本吻合。
6) cyclic simple shear
循环单剪
1.
In this paper,the cyclic simple shear tests of the saturated soil of saturation 95 %,92 %,88 % and 83 % were carried out under the consolidation pressure of 50 kPa,100 kPa and 200 kPa respectively.
在50,100,200 kPa三种固结压力下分别对饱和度为95%,92%,88%,83%的饱和土样进行了循环单剪试验,得到了4种土样在3种固结压力下的最大动剪模量Gdmax和最大阻尼比Dmax,以及动剪模量比G/Gdmax-γ和阻尼比D/Dmax-γ归一化数值,并进行了对比分析。
2.
The cyclic simple shear tests of the saturated soil with saturation 95%,92%,88% and 83% were carried out under the consolidation pressure of 50 kPa,100 kPa and 200 kPa,respectively.
在50kPa、100kPa和200kPa 3种固结压力下分别对饱和度为95%、92%、88%和83%的土样进行了循环单剪试验,得到了该土样在4种饱和度、3种固结压力下的最大动剪模量Gdmax以及动剪模量比G/Gdmax-γ归一化曲线。
3.
Furthermore,undisturbed samples of each layer soil are taken out,and the maximum dynamic shear modulus is obtained by laboratory cyclic simple shear tests.
此外,取出了场地各层土的原状土样,进行了室内循环单剪试验,获得了各层土的动剪模量,并与剪切波速的计算结果进行了比较分析。
补充资料：单色剪纸
单色剪纸 亦称“黑白剪纸”。指一种颜色的剪纸。有红、绿、褐、黑、白等。是流行最广，数量最多的一种剪纸。一般来说，美化室内环境以及烘托喜庆气氛的单色剪纸，多以红色为主，用于刺绣的则系白色。单色剪纸虚实对比强烈，黑白明快醒目，作风单纯大方，感染力强。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条