1) teeth thickness calculation
齿厚计算
1.
It is considered that there is short of introduction for teeth thickness calculation of involute helical cylindrical gear with end face module as standard in correlative documents,the article deduces the teeth thickness calculation equation taking end face as parameter,which has been put into practice.
针对有关资料中对以端面模数为标准的渐开线斜齿圆柱齿轮的齿厚计算缺乏介绍的情况,自行推导出以端面为参数的斜齿轮之齿厚计算公式,并在实践中得到应用。
2) worm wheel tooth thickness calculation
蜗轮齿厚计算
3) Tooth thickness surveying calculation
齿厚测量计算
4) thickness calculation
厚度计算
1.
The actual thickness calculation methods of the asphalt adding paving course are analyzed.
根据公路养护技术规范,研讨旧水泥混凝土路面使用状况调查的内容和方法,提出旧水泥混凝土路面使用性能的更实用、更全面的评价指标和评定标准,分析实用的加铺层厚度计算方法,提出防止产生反射裂缝的设计措施。
2.
Weir Plate Thickness Calculation for Horizontal Vessels;
在卧式分离、储存容器中,根据不同的工艺要求,通常需要设置中间挡板,但现有的标准中,没有关于挡板厚度计算具体的方法。
5) wall thickness calculation
壁厚计算
1.
For thick wall cylinder or thin wall cylinder,the formula for its wall thickness calculation which is expressed in exponential form is more precise theoretically.
学习运用公认的第三强度理论和塑性失效准则对承受内压的厚壁圆筒体应力分析,可得到与ASME CODE I卷2007版在新增A-317条文推出的相同的以指数形式表达的圆筒体壁厚计算式。
6) calculated thickness
计算厚度
1.
After having studied the new standard GB150-1998, the author stated and analyzed, in this paper, the main differences on the provisions of calculation pressure, design pressure,calculated thickness, practical shell thickness, pressure test and leakage test from the same provisions in GB150 - 89.
根据对新国标的学习所得，从设计角度对有关计算压力与设计压力、计算厚度与成品厚度、压力试验与气密性试验等主要修订条文间的差异进行阐述分析。
2.
When the pressure vessel is designed without checking hole, the calculated thickness of the pressure vessel written on the drawing, sometimes, is not the same illustrated in GB150-89.
在压力容器中不设置检查孔所需标注的“计算厚度”,并非是GB150-89中的“计算厚度”,应考虑参与补强所需厚度这个因素。
补充资料：齿（齿所）
齿（齿所）
齿（齿所） 病名。系指牙齿被醋浸渍的病证。《诸病源候论》卷二十九：“齿（齿所），齿伤酢也。齿者骨之所终，髓之所养，髓弱骨虚，风气客之，则齿（齿所）。”酢，同醋。参见齿齼条。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条