1) rewarming rate
复温速率
1.
Theoretical analysis showed that survival rates not less than 80% were achieved when the cooling rate and rewarming rate were not lower than 400 ℃/min .
模拟计算以Karlsson模型为基础,结果显示,近似实现脐带血干细胞玻璃化的降温速率、复温速率应分别不低于400℃/min和500℃/min;在此速率下采用两步法冷冻脐带血干细胞,冻存前后对样品细胞计数,浓度分别为1。
2.
At last,according to its effect of clinic application,some major parameters as working pressure,cooling rates,rewarming rates are discussed.
最后根据临床应用对装置的工作压力、冷冻速率、复温速率等重要参数进行讨论。
2) Cooling rate
降温速率
1.
120～150 ℃·h-1 cooling rate is helpful obtain indium oxide in single phase with relative density 99.
h-1的降温速率可以得到纯度为99。
2.
ln order to study the effect of water suppliment in vegetable vacuum cooling, crown daisy -a representative leaf -vegetable were chosen as experimental object to study the effect of water suppliment on relative energy, cooling rate and water decreasing rate in the vacuum cooling equipment.
为了研究喷水率对真空冷却蔬菜的影响,本文选取叶菜类有代表性的茼蒿在自行设计的装置中进行了真空冷却实验,考察了不同喷水率对相对能耗、降温速率和失水率的影响。
3.
The influence of cooling rate on the room temperature resistivity of PTCR ceramics was studied emphatically.
着重研究降温速率对PTCR室温电阻率的影响。
3) heating rate
升温速率
1.
Effect of heating rate on microstructure and mechanical properties of composite solder joints;
升温速率对复合钎料显微组织和力学性能的影响
2.
Influence of heating rate on LSCF phase impurity;
升温速率对LSCF相纯度的影响
3.
The effects of adding different inorganic compounds at a mass ratio 1∶1∶1[K2CO3∶NaCl∶Al2O3],heating rate and pressure were measured.
为了更好地利用工业污泥,有必要对它的燃烧特性进行研究,因而利用热重法研究了由3种典型的工业污泥按质量比1∶1∶1混合后的多组分试样在掺混含不同金属元素混合物、不同升温速率以及加压下的燃烧特性。
4) temperature rising rate
升温速率
1.
Test and research on relationship between temperature rising rate and coal oxidized features;
升温速率与煤氧化特征关系的实验研究
2.
The inclusion complexes of β-CD and 1-MCP were studied by temperature-programmed themogravimetry,from which the TG/DGT spectra were obtain at a temperature rising rate 10～40?K/min.
用程序升温热重法对-βCD与1-MCP包结物的热分解动力学进行了研究,考察了升温速率对TG/DTG谱图的影响,并用单一升温速率法和多个升温速率组合法分别作了动力学分析。
3.
Experimental researches on the combustion property of Huadian oil shale have been done by the FTIR,and obtain its combustion property curves under different temperature rising rate,and analyse combustion property of oil shale under certain temperature rising rate,find out the fittest combustion temperature region of oil shale.
在德国NETZSCH公司生产的STA40 9型热综合分析仪 (简称FTIR)上进行桦甸油页岩的燃烧特性实验研究 ,得到不同升温速率下的油页岩燃烧特性曲线 ;分析了油页岩在一定升温速率下的燃烧特性 ,找出油页岩最适合的燃烧温度区间 ;通过数据分析 ,利用Freeman Carroll法得到油页岩燃烧化学反应的动力学参数 ,为油页岩的有效开发与经济利用提供了可靠的理论依
5) temperature rise rate
升温速率
1.
According to the model and the test data, the temperature rise rate and generating heat of different tempe.
介绍了一种绝热氧化实验设备及其实验方法,利用该设备测试了3种煤样的低温氧化自热升温过程,成功实现了100g左右小煤样的煤自然发火过程模拟试验研究,获得了煤在绝热状态下的氧化升温曲线,建立了煤的绝热氧化产热量计算的数学模型,对实验过程中煤在绝热条件下的氧化产热量进行了计算,获得了不同温度段煤的绝热氧化升温速率和产热速率。
2.
An analysis was conducted of TGA FTIR spectrogram of pulverized coal combustion at a temperature rise rate of 15℃/min and under simulated atmospheric conditions.
用热重和红外联用的方式进行了以某一煤种为代表的煤粉在空气条件下的燃烧特性试验,介绍了利用TGA-DSC-FTIR联用手段研究煤粉燃烧特性的实验方法,分析了煤粉在升温速率为15℃/min和模拟空气气氛条件下燃烧的TGA-FTIR谱图。
6) temperature variation rate
温变速率
1.
The experimental results show that the SES system can provide high temperature uniformity and appropriate temperature variation rate,the temperature distributions of both high and low experiment conditions are within ±3(°C) range.
结果表明,所建立的对接机构综合试验台环境模拟分系统能够满足对接试验过程对温度均匀性和升降温速率可控性的要求,高温和低温过程的温度均匀性均能维持在±3°C,通过控制送、回风温差可有效控制温变速率。
补充资料：温病劳复
温病劳复 温病劳复 病证名，劳复证之一。出《诸病源候论·温病劳复候》。指温病初愈，津液未复，血气尚虚，因劳动过早而生热，热气还入经络，使之复病。参见劳复等条。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条