1) Intersection degree

相交度
1.
To define upper and lower probabilities by using the basic probability of set,and then form the belief;to define the inclusion degree and intersection degree of the fuzzy set by using the subordinate function and make the belief theory can be spread in the fuzzy set and then get a reasonable inference method in using uncertainty and fuzziness.
通过使用集合的基本概率定义上限、下限概率,形成信度;通过隶属函数定义模糊集合的包含度、相交度,使信度理论在模糊集合得以扩张,得到了利用不确定性及模糊性的一个合理的推理方法。
2) intersection
[英][,ɪntə'sekʃn] [美]['ɪntɚ'sɛkʃən]

相交度
1.
A new and simple axis intersection measurement method is put forward considering the characteristics of three-axis hydraulic simulator.
根据三轴仿真转台自身的结构特点,针对决定其精度的重要环节——相交度的测试问题,提出了新的简洁的测试方法,从而为三轴仿真转台的安装、调试提供可靠数据,以保证其精度指标达到设计要求。
2.
Through measuring the slight change of the other axis line in position when one axis is in 0°and 180°positions,the intersection of the two axis lines is calculated.
本文提出了用经纬仪和固定在轴孔上的两个十字靶标将轴系的回转轴线引出的方法,并通过测试一个轴在0°和180°两个位置时,另一轴的轴线在空间位置上产生的微小变化,计算了两轴线的相交度,并对相交度测试进行了误差分
3) crossing length

相交长度
1.
The ratiocination formular of multiple thread crossing length of the main/subsidiary screw;
多头主副螺纹螺杆螺纹相交长度计算公式的推导
5) angle of cut

相交角度
1.
Therefore,this paper analyzes the design of adapter pipe from two aspects: the effect of angle of cut of pipeline and adapter pipe on pipeline stress and deformation;and the relationship of the sizes of adapter pipe with pipeline stress and deformation,hoping to provide references for designers of adapter pipe.
从管道与接管的相交角度对管道应力、变形的影响,接管的大小与管道应力、变形间的关系2个方面进行分析,以供设计师设计管路时参考。
6) axis intersection

轴线相交度
1.
The displacements of two middle axis positions are measured by a dial gauge when the outer axis is in the 0° and 180° positions,then the axis intersection between the vertical axis and the horizontal axis is calculated.
用千分表测出三轴转台的竖直轴分别位于 0°和 180°时两水平轴的轴线位移 ,可计算出水平轴与竖直轴的轴线相交度。
补充资料:V形相交纹
V形相交纹 青铜器纹饰之一。以两“V”形相互交叉,作一颠一倒排列,尖角和四周饰以变云纹。盛行于战国时期。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条