说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 防抱死系统
1)  ABS [英][æbz]  [美][æbz]
防抱死系统
1.
ABS(Anti-lock Braking System)is a kind of main equipment to improve vehicle braking performance and driving security.
制动防抱死系统(ABS)是提高车辆制动性能和行车安全性的重要装置。
2.
For the key of the ABS control logic unit, a stateflow model is established based on definite state machine theory.
在对某车型进行动力学分析的基础上,建立了与防抱死系统(ABS)相关的数学模型;根据有限状态机理论对防抱控制器的关键———防抱控制逻辑建立了Stateflow模型;并且以车轮角加速度和滑移率为控制对象,在Matlab/Simulink仿真软件下,分别对汽车在单一路面和附着系数突变的路面上制动时的情况进行了仿真研究。
3.
A four-wheel vehicle model and simulation for ABS application,including body model,tyre model,brake model and wheel speed detector model as well as the air braking system with real channels and valves are imbedded for real time simulation.
建立了一种四轮车辆制动防抱死系统 (ABS)的车辆模型、轮胎模型、路面状况模型和轮速传感器模型 ,嵌入了气压制动系统和ABS控制逻辑模拟 ;采用Matlab/Simulink模拟了汽车在直线制动 ,转弯制动和不同附着系数路面制动的运动状态 ,为ABS产品的开发提供了依据 。
2)  anti-lock braking system
防抱死系统
1.
In order to study the braking effect of ABS with different kinds of control rules,the intelligent weight function fuzzy control method of ABS based on the slipping coefficient is introduced to establish anti-lock braking system.
为分析防抱死系统的不同控制方式对整车制动性能的影响,基于滑移率的智能权函数模糊防抱死控制思想建立防抱死系统数学模型。
3)  ABS [英][æbz]  [美][æbz]
防抱死制动系统
1.
Fault Diagnosis of ABS;
防抱死制动系统的故障诊断
2.
Overhaul on ABS of TOYOTA CAMRY Car;
丰田佳美轿车防抱死制动系统的检修
3.
A simulation model of the integrated dynamic control system of active front steering(AFS)and anti-lock braking system(ABS)is set up using carsim and matlab/simulink.
以车辆动力学软件Carsim和Matlab/Simulink为平台,分别建立了基于滑模变结构控制的主动前轮转向(AFS)和滑移率门限控制的防抱死制动系统(ABS)控制器模型,并将2种控制系统进行了集成,建立了联合仿真模型。
4)  anti-lock braking system(ABS)
防抱死系统(ABS)
5)  Anti-lock braking system
防抱死制动系统
1.
Simulation study of vehicle s anti-lock braking system based on Matlab/Simulink;
基于Matlab/Simulink的汽车防抱死制动系统的仿真研究
2.
To provide an economic and efficient test method for vehicle anti-lock braking system(ABS) in laboratory,the idea of designing a dynamic test-bed is researched and developed,which can simulate actual working status of automobiles well and truly.
针对目前防抱死制动系统(ABS)产品试验过程中存在的弊端,对汽车、摩托车ABS性能试验台作了深入研究,为了给汽车ABS提供一种在实验室环境下经济高效合理的测试手段,提出一种能够较为准确地模拟汽车实际工作情况的动态试验台设计思路。
3.
Assuring the control effect and dependability of anti-lock braking system(ABS) under various special working conditions is important for ABS.
为保证汽车防抱死制动系统(ABS)在特殊工况下的控制效果和可靠性,研究了不平路面制动、低速状态制动、转向制动、过沟坎制动4种典型ABS特殊工况,根据特殊工况的识别、控制量计算补偿和控制流程调整的思路,提出通过轮加速度信号识别路面不平度的不平路面补偿控制算法、上升下降沿同时采样的低速补偿控制算法、转向识别补偿算法和沟坎识别防止ABS误动作补偿算法。
6)  ABS [英][æbz]  [美][æbz]
制动防抱死系统
1.
Co-simulation of ABS for Cars in ADAMS and SIMULINK;
汽车制动防抱死系统的ADAMS/SIMULINK联合仿真
2.
The vehicle Antilock Braking System (be short for ABS) has been widely applied on the vehicles,in order to improve the safety.
为提高汽车行驶安全性,制动防抱死系统(简称ABS)在汽车上得到了广泛应用。
补充资料:abs防抱死系统
“ABS”是英文“Anti-lockBreakSystem”的缩写,中文译为“防死锁刹车系统”。它是一种具有防滑、防锁死等优点的安全刹车控制系统。没有安装ABS系统的车,在遇到紧急情况时,来不及分步缓刹,只能一脚踩死。这时车轮容易抱死,加之车辆冲刺惯性,便可能发生侧滑、跑偏、方向不受控制等危险状况。而装有ABS的车,当车轮即将到达下一个锁死点时,刹车在一秒内可作用60至120次,相当于不停地刹车、放松,即相似于机械的“点刹”。因此,可以避免在紧急刹车时方向失控及车轮侧滑,使车轮在刹车时不被锁死,轮胎不在一个点上与地面摩擦,加大了摩擦力,使刹车效率达到90%以上。
一般说来,在制动力缓缓施加的情况下,ABS多不作用,只有在制动力猛然增加使车轮转速骤消的时候ABS才发生效力。ABS的另一主要功效是制动的同时打方向躲避障碍。因此,在制动距离较短,无法避免触障时,迅速制动转向,是避免事故的最佳选择。
值得注意的是,汽车装有ABS,并不代表就一切万事大吉了。所以在此奉劝装有ABS系统的车主,万不可放心大胆地超能力驾驶,引发事故,也许ABS也救不了你。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条