1) making test
关合试验
1.
Based on the understanding of international standard IEC 62271-100 for high-voltage AC circuit-breakers, the authors give some general introduction to the requirements for synthetic making test, in which the stress put on the switching devices and methods (substitute methods) for making test are mainly included.
根据对国际电工委员会(IEC)制定的高压断路器关合试验标准的理解,对相控关合试验的相关要求进行了探讨, 包括试品开关上所加负荷情况以及试验方法和替代试验方法,详细分析了断路器由预击穿燃弧开始的短路关合过程, 引入了绝缘强度下降率及其变化率(即以外施电压波形最大斜率为基准的相对合闸速度),并分析了该变化率取不同值时关合过程中断路器所受的负荷情况(包括预燃弧时间、预燃弧能量及电动力等)及其表现出来的关合性能。
2) Synthetic making test
合成关合试验
1.
The Study of Fast Making Switch for Synthetic Making Test Circuit under Full Voltage;
全电压合成关合试验快速关合开关的研究
3) short circuit making capacity test
短路关合试验
1.
During short circuit making capacity test of high voltage switchgear, to enable relay protection device to withstand repeated heavy current, a set of specific protective tripping device was developed.
经长期使用表明,该装置运行灵敏可靠,耐受大电流能力强,完全满足短路关合试验的要求。
5) clutch switch test
离合器开关试验
6) synthetic making test circuit
合成关合试验回路
补充资料：关合
1.关闭。 2.关联照应。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条