1) initial deflection value
初始弯沉值
2) initial bending
初始弯曲
1.
Width-thickness ratio of steel plates in concrete-filled rectangular thin-walled steel tube columns subjected to axis force with initial bending
考虑初始弯曲矩形薄壁钢管砼柱管壁屈曲分析
2.
The dynamical characteristics of a maneuvering rotor with initial bending running at a constant speed were studied.
研究了飞行器内等速运行的初始弯曲转子的动力学特性 ,分析了飞行器机动飞行对转子系统振动响应的影响 。
3.
A new method of reducing the peak vibration amplitude of a rotor with initial bending is studied in the paper.
本文从理论上研究了控制初始弯曲引起的转子振动幅值的一种新方法。
3) initial permanent deflection
初始弯曲
1.
A rotor-stator rubbing Jeffcott model of a rotor system with mass unbalance including mass eccentricity and initial permanent deflection is set up and the corresponding governing equation of motion is derived by d’Alembert principle.
建立了一个具有初始弯曲的不平衡转子模型,通过d'Alembert原理推导了振动方程。
4) initial moment
初始弯矩
1.
Based on the calculation formulae for load bearing capacity of concrete members strengthened with FRP (Fiber Reinforced Polymer) laminate,the effect of initial moment on strengthened beams is discussed under two different states-ultimate limit state (ULS) and limited stress state for concrete and steel reinforcement.
为探讨结构不卸载或部分卸载情况下外贴纤维片材加固时,结构初始状态对承载力设计计算的影响,根据极限状态和容许应力法分析了受弯构件加固后承载力计算公式,考查了初始弯矩对承载力的不同影响。
2.
The effect of initial moment on the load capacity,the stiffness and the configuration of crack is also studied.
通过碳纤维布加固混凝土梁和未加固梁模型的受弯性能对比试验 ,研究了初始弯矩大小对极限承载力、刚度、裂缝形态的影响 ,为碳纤维布加固混凝土桥面板工程的实际应用提供了依
5) initial depositio
初始沉积
1.
The initial deposition mechanism of nickel was studied by means of XPS, SAM and SEM.
通过 XPS、SAM和 SEM对化学镀镍的初始沉积机制进行了研究 。
6) initial value
初值，始值，起始值
补充资料：聚沉值
分子式：
CAS号：
性质：在指定条件下使胶体发生聚沉所需的电解质的最低浓度，通常以mmol/L为单位。
CAS号：
性质：在指定条件下使胶体发生聚沉所需的电解质的最低浓度，通常以mmol/L为单位。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条