说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 时空处理增益
1)  Gain of time-space processing
时空处理增益
2)  disposal gain
处理增益
1.
And by calculating and comparing the parameters of spread spectrum disposal gain and the bit error rate of the three common jamming methods(wide-band noise jamming, narrow-band noise jamming and pulse jamming),the authors conclude that the pulse noise has a better jamming effectiveness, and give the corresponding simulation result
简要分析了跳频通信的基本特点和优点,通过计算和比较卫星通信常见的几种干扰方式(宽带噪声干扰、窄带噪声干扰和脉冲干扰)的处理增益和误码率,得出了脉冲干扰对跳频技术下的卫星通信具有较好的干扰效果这一结论,并给出了与理论分析相一致的仿真结果。
3)  processing gain
处理增益
1.
As different types of traffic have different bit rates, required bit error rate (BER) and processing gain, it was reasonable to give different types of media different transmission power which can be obtained from the power control method.
该方案根据多媒体DS-CDMA系统中不同业务具有不同数据速率、误码率门限和处理增益的特点,对不同的业务使用不同的基站接收功率。
2.
Anti-interference performance of white noise for the spread-spectrum systems is no better than that of the digital communication system with the matched filter by processing gain of the spread-spectrum systems.
通过对直扩系统处理增益分析,得到了直扩系统不比未扩频的匹配滤波器数字调制系统具有更强的抗白噪声功能的结论。
3.
By analyzing the correlation between the suppression capability of FH communication for multiple interferences and FH processing gain,a method for calculating the anti-jamming capability of FH communication system for wide-band interference,multi-tune interference and tracking interference is given in this article.
通过对跳频通信对多种干扰信号的抑制能力与跳频处理增益相关性的分析,研究了跳频通信系统对宽带干扰、多频点干扰、跟踪干扰的抗干扰能力的计算方法。
4)  process gain
处理增益[光]
5)  Space-time processing
空时处理
1.
The principles of code filter are analyzed under the condition of single satellite and multi-satellite,and the restraining rules of space-time processing under two different conditions are achieved.
首先介绍一种基于码滤波原理的抑制GPS多径效应的方法的原理,然后分别针对单卫星和多卫星进行了码滤波的理论分析,得到了两种不同情况下的空时处理的约束准则;依据分析得出的结果,设置了仿真条件进行验证,证明了提出的抑制方法的可用性。
2.
The applying of space-time processing so greatly increases the freedoms of degree as to enhance the anti-jammer capability remarkably.
采用本文新颖之处是采用联合空时处理技术,在不增加阵元的情况下,能使阵的自由度大大增加,从而使抗干扰能力有质的提高。
3.
Space-time processing technique combines time domain signal processing and spatial signal processing.
空时处理技术联合时域和空域信号处理技术,充分利用无线信道的空时结构特征,弥补了时域信号处理和空域信号处理二者的局限,能够提高无线通信系统的容量、覆盖范围和传输速率。
6)  space time processing
空时处理
1.
Space time processing which combines these two methods can improve the performance and capacity of the system greatly.
多用户检测和阵列天线是直扩码分多址系统中两种减轻多址干扰的关键技术 ,将两者结合起来的空时处理能大大提高系统的容量和性能。
2.
It is of significance for space time processing to be realized in mobile communications.
仿真实验表明 ,该方法性能良好 ,对空时处理在移动通信中的实用化具有积极的意义 。
3.
Array freedom is analysized in this paper with spatial processing and space time processing for TDMA signal under multi path to eliminate inter symbol interference and co channel interference.
文中分析了空域处理和空时处理在消除TDMA信号多径环境下码间干扰 (ISI)和共道干扰(ICI)的阵列自由度。
补充资料:表面处理、热处理关连用语英汉对照

age hardening 时效硬化 ageing 老化处理
air hardening 气体硬化 air patenting 空气韧化
annealing 退火 anode effect 阳极效应
anodizing 阳极氧化处理 atomloy treatment 阿托木洛伊表面
austempering 奥氏体等温淬火 austenite 奥斯田体/奥氏体
bainite 贝氏体 banded structure 条纹状组织
barrel plating 滚镀 barrel tumbling 滚筒打光
blackening 染黑法 blue shortness 青熟脆性
bonderizing 磷酸盐皮膜处理 box annealing 箱型退火
box carburizing 封箱渗碳 bright electroplating 辉面电镀
bright heat treatment 光辉热处理 bypass heat treatment 旁路热处理
carbide 炭化物 carburized case depth 浸碳硬化深层
carburizing 渗碳 cementite 炭化铁
chemical plating 化学电镀 chemical vapor deposition 化学蒸镀
coarsening 结晶粒粗大化 coating 涂布被覆
cold shortness 低温脆性 comemtite 渗碳体
controlled atmosphere 大气热处理 corner effect 锐角效应
creeping discharge 蠕缓放电 decarburization 脱碳处理
decarburizing 脱碳退火 depth of hardening 硬化深层
diffusion 扩散 diffusion annealing 扩散退火
electrolytic hardening 电解淬火 embossing 压花
etching 表面蚀刻 ferrite 肥粒铁
first stage annealing 第一段退火 flame hardening 火焰硬化
flame treatment 火焰处理 full annealing 完全退火
gaseous cyaniding 气体氧化法 globular cementite 球状炭化铁
grain size 结晶粒度 granolite treatment 磷酸溶液热处理
graphitizing 石墨退火 hardenability 硬化性
hardenability curve 硬化性曲线 hardening 硬化
heat treatment 热处理 hot bath quenching 热浴淬火
hot dipping 热浸镀 induction hardening 高周波硬化
ion carbonitriding 离子渗碳氮化 ion carburizing 离子渗碳处理
ion plating 离子电镀 isothermal annealing 等温退火
liquid honing 液体喷砂法 low temperature annealing 低温退火
malleablizing 可锻化退火 martempering 麻回火处理
martensite 马氏体/硬化铁炭
metallikon 金属喷镀法
metallizing 真空涂膜 nitriding 氮化处理


~

nitrocarburizing 软氮化 normalizing 正常化
oil quenching 油淬化 overageing 过老化
overheating 过热 pearlite 针尖组织
phosphating 磷酸盐皮膜处理 physical vapor deposition 物理蒸镀

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条