说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 最佳灌水量
1)  optimal irrigation
最佳灌水量
1.
It used soil column modeling gypsum to improve basified soil, and concluded that the optimal irrigation has much to do with conducting ways of gypsum.
本文运用土柱模拟石膏改良碱化土壤的过程,认为最佳灌水量与石膏的处理方式有关,石膏与土混匀的处理只需保证最佳灌水量为134。
2)  Optimum charge
最佳充灌量
3)  optimum filling quantity
最佳灌注量
1.
The principle of optimum filling quantity is put forward in this article .
提出了最佳灌注量原理。
4)  optimum water
最佳水量
5)  best enema dosage
最佳灌肠剂量
6)  Optimum moisture content
最佳含水量
1.
Optimum moisture content of rapeseed for ultradry storage at different temperature;
油菜种子超干燥保存的最佳含水量研究
2.
Using the regress analysis method and the numerical analysis method to obtain the extremum of the compaction test,we may accurately extract the biggest dry density and the optimum moisture content.
利用回归分析法和数值分析法对击实试验数值进行分析,可以较准确地求出最大干密度和最佳含水量。
3.
The density is one of main control performances for projects during the highway construction, optimum moisture content and maximum dry density among them are keys for calculating and controlling the density.
公路建设中 ,密实度是众多工程项目质量控制主要指标之一 ,其中最佳含水量和最大干密度是计算和控制密实度的关键 ,本文拟采用数值分析中的插值多项式方法求解 ,结合简单的计算程序 ,求解方法简单 ,结果准确 ,并可对试验结果进行有效的校
补充资料:饱和持水量测定


饱和持水量测定
measurement of saturation moisture capacity

  匕aohe ehishuiliang eeding饱和持水t测定(measurement of satu-ration moisture eaPaeity)土壤农业水文特性测定项目之一,是测定土壤孔隙完全充满水时的l几壤湿度。饱和持水t所占容积等于土壤总孔隙度,可用来鉴定土壤水分饱和程度和总孔隙度。 测定方法是浸水饱和法。即在欲测地段上,用容重环刀取原状土,取土方法与测定卜壤容重时取_L相同(见土壤容l测定)。把装有未遭破坏土样的环刀称重后,使其有孔底一端(内垫滤纸)朝下,放在盛水的平底磁盘中或充满水的砂层上,使盘内水面与环刀上缘保持一样高,切勿使水面淹没环刀,以免影响空气自土壤孔隙排出,使水不能充满孔隙。经过一定时间后(砂土4一8小时,粘土8一12小时)迅速取出,用盒盖托住称重。然后再放入盘中,继续使水充满孔隙,直至前后两次重量无显著差异为止。为了计算环刀中土体的干土重,必须在同一土层上,另取土样,用称重烘干法测其湿度。用下式计算饱和持水量(占干土重的百分数): 环刀中上样吸水饱和*、、、。_后的含水量吧刊’寸小里一环万币王释的不干甭入川U.式中上样干土重(克)=环刀中的湿土重(克)xl()0100十上样湿度的百分数 此外,通过下式也可计算饱和持水量(占干土重的百分数):饱和持水量二总孔隙度 容重火10()%式中总孔隙度二1一宣重比重(林家栋)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条