说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 正交差分解调
1)  quadrature differential demodulation
正交差分解调
1.
An improved quadrature differential demodulation algorithm and a timing Synchronization algorithm based on 2FSK demodulation are proposed.
文中针对2FSK解调中这个问题,在分析传统方法的基础上提出了一种改进的正交差分解调算法和基于滑动积分的联合定时算法。
2)  quadrature demodulation errors
正交解调误差
1.
The quadrature demodulation errors in broadband phased array radar will influence the performance of the broadband beamforming.
论文以宽带信号和正交解调误差模型为基础,求解了时域和频域宽带波束形成中自相关矩阵的表达式。
3)  generalized forcast error variance decomposion
预测误差方差正交分解
4)  quadrature demodulation
正交解调
1.
Errors analysis and clibration of subsampling digital quadrature demodulation;
基于欠采样数字正交解调的误差分析及校正
2.
A method for compensation of quadrature demodulation of synthetic aperture radar;
一种合成孔径雷达正交解调误差校正方法
3.
A novel method for the measurement of PWEIS by using quadrature demodulation was presented and the measurement system was constructed based on the anal.
为此分析了人体组织电阻抗测量的特点,提出了基于正交解调的脉搏波电阻抗谱测量方法,并构建了人体电阻抗谱及脉搏波阻抗谱实验测量系统。
5)  orthogonal demodulation
正交解调
1.
The application of orthogonal demodulation in OFDM signal demodulation;
正交解调算法在OFDM信号解调中的应用
2.
Implementation of quadratic orthogonal demodulation and built-in self test
二次正交解调算法及内建自测试的实现
6)  differential detection
差分解调
1.
The paper proposes a new differential detection method of PCM/DQPSK signal.
提出了一种新的DQPSK信号差分解调的软件实现方法,详细介绍了此种软件差分解调方法的基本原理及实现过程,分析了解调过程中多普勒频率对解调结果的影响。
补充资料:调制与解调电路


调制与解调电路
modulation and demodulation circuit

  角按调制信号的瞬时值正比变化的电路,即 u。(t)=Ucmoin[(叭t+无pU。。sinomt)t〕(3)式中kp为调相比例系数。 实现调制与解调的具体电路见调制器与解调器。t}oozh一yu]一et一ood一onlu调制与解调电路(modulation and demo-dulation eireuit)用一个较低频率的信号去控制另一个较高频率的信号的某一参数(振幅、频率、相位)的电子电路称为调制电路,实现从已调制信号中恢复原始信号的电子电路称为解调电路。 调制、解调技术广泛用于通信、广播电视、自动控制及检测系统中。例如,在无线通信中被传输的原始信号。m(t)是某人的讲话、音乐等音频信号。音频信号容易被大气层吸收,不易传输到远方。要将音频信号传输到远方,首先需要将音频信号调制到另一个频率高得多的载波信号u。(t)上去,得到一个已调制信号“。(t),u。(t)通过发射机就能传输到远方去。在远方通过接收机接收到u。(t),然后再通过解调电路恢复出原来的音频信号。调制电路的方框图如图所示。图中调制信号“、(t)一Umtnsin。韶;载波信号uc(t)一UcmsinQJct;通常叭》叽。调制电路的输出信号u。(t)称为已调制信号。根据已调制信号被调制参数的不同,调制电路可分为振幅调制、频率调制和相位调制三种类型。 (1)振幅调制电路。实现已调制信号的振幅按调制信号的瞬时值成正比变化的电路,即 “。(t)=(Uem+KUmmsinomt)Sinoet =ue。(1+mosin。用t)sinoet(1) KU___、.、_.__、,~、一~一_式中m。一拱型称为调幅度。总是满足ma毛1。K为~’‘’‘aUc。曰’月“,「因~。‘~~’附‘~‘~一“一/‘调幅比例系数。 (2)频率调制电路。实现已调制信号的频率按调制信号的瞬时值正比变化的电路,即 u。(t)=Ueosin[(唤t+kfUmosin。。t)t〕(2)黑:}调制电路调制电路方框图 式中k,为调频比例系数。肠(I)(3)相位调制电路。 实现已调制信号的相位
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条