1) angular constriction

角收缩
2) azimuthal pinch

角向收缩
3) shrinkage angle

收缩角
1.
The relation between mould cavities and plastic gears was obtained through calculation and the shrinkage angle and shrinkage rate were discussed.
通过对塑件成型制品的收缩规则和收缩特性分析,提出了塑料齿轮向"对称中心"收缩的概念,利用实例计算,得出模具型腔与塑料齿轮的关系式,并对收缩角和实际收缩率进行了阐述。
4) nozzle diminishing-angle

喷嘴收缩角
5) triangle contraction

三角形收缩
6) entrance shrinking angle

入口收缩角
1.
This paper is focused on the analysis of three nozzles with different entrance shrinking angle with FEM method.
文中运用有限元法对三种不同入口收缩角的喷嘴进行了分析。
补充资料:收缩中(晚)期喀喇音-收缩晚期杂音综合征
收缩中(晚)期喀喇音-收缩晚期杂音综合征
即"二尖瓣脱垂-喀喇音综合征"。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条