1) siliconizing treatment processes
渗硅工艺
2) liquid silicon infiltration processing(LSIP)
液相渗硅工艺
3) infiltration process
浸渗工艺
1.
The influence of wetting angle, capillary force, infiltration pressure, infiltration temperature, infiltration time and interface on the infiltration process for RC-MMCs was also introduced.
综述了润湿角、毛细力、浸渗压力、浸渗时间和浸渗温度以及界面对网络陶瓷增强金属基复合材料浸渗工艺的影响,提出下一步需要改善浸渗行为的措施。
4) boronizing process
渗硼工艺
1.
The boronizing process parameters of Cr12MoV steel and the RE addition were optimized by orthogonal experiment.
采用正交试验方法,优化出Cr12MoV钢最佳的渗硼工艺参数为950℃×5 h及最佳的稀土加入量为0。
2.
The method of orthogonal experiment was used to investigate the effect of parameter of boronizing process on the thickness of the boride layer.
运用正交实验法来确定渗硼工艺的参数(渗硼温度、渗硼时间、稀土加入量和铬加入量)对渗硼层厚度的影响，从而确定合理的渗硼工艺。
5) cast-penetration technics
铸渗工艺
1.
By varying cast-penetration technics ,the influence of thickness and quality in composite layer with Si by casting on the surface of cast steel were studied.
研究了不同铸渗工艺对铸钢件表面铸渗硅复合层厚度和质量的影响。
6) carburizing process
渗碳工艺
1.
This paper deals with the carburizing process,microstructure,mechanical properties and quenching distortion of the air cooling low carbon bainitic steel.
对低碳贝氏体钢的渗碳工艺、显微组织、力学性能、淬火变形进行了研究。
补充资料：渗渗
1.寒冷貌。 2.指因害怕而产生发冷的感觉。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条