1) trimming control
配平控制
1.
In view of the main drawbacks of traditional trimming control system of helicopter W.
针对原直升机风洞试验配平控制系统的缺点 ,提出将神经网络控制技术引入该配平系统的设想 ,具体设计了神经网络配平控制器 ,在MATLAB6。
2) pitch trim wheel
俯仰配平控制轮
3) mixture control
配料控制
1.
A kind of mixture control system,based on dynamic neural network,is designed through analyzing the influence precision factors of mixture.
通过对影响配料精度因素的分析,设计了一种基于动态神经网络的配料控制系统。
4) air flow control
配风控制
5) control allocation
控制分配
1.
Research on fault-tolerant control allocation algorithm of a UUV propulsion system;
UUV推进系统容错控制分配算法研究
2.
Generalized inverse control allocation method based on PSO
基于粒子群优化算法的广义逆控制分配方法
3.
For unmanned aerial vehicle’s(UAV’s) control allocation problem which arises from the wide use of multiple aero surfaces,a robust algorithm based on closed-loop generalized inverse is proposed.
针对无人机广泛采用先进操纵面带来的控制分配问题,提出了基于闭环广义逆的鲁棒控制分配新方案。
6) batching control
配料控制
1.
Design of distributed batching control system which is based on electronic belt weigher;
基于电子皮带秤集散配料控制系统的设计
2.
This paper introduces a PID(proportional integral derivative) algorithms whose setting value is revised by the past errors in the batching control system, which greatly improve the quality of the controlling.
针对这一问题,提出了一种设定值修正的PID算法,并在稳定土配料控制系统中进行了实施,配料精度达到98。
3.
Concrete batching control system is widely applied in construction and metallurgy industry.
混凝土配料控制系统是建筑、冶金等行业应用广泛。
补充资料：操纵力配平
见飞机配平。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条