1) hoop-stress
围箍压痕法
1.
In this paper, in the view of microhardness measurement, a new method to measure the residual stress, named the method of hoop-stress is investigated.
本文从微硬度量测方法得到启发,提出了一种新型的残余应力测试方法-围箍压痕法。
2) Guwei treatment
箍围法
3) encircling lesion with drugs therapy
箍围疗法
4) hooping technique
围箍
1.
This paper expounds the principle of treating the existing buildings collapsible loess foundation by using the hooping technique of lime-soil comp action pile with small diameter, and through the application in some concrete en gineering, puts forward the concrete methods and requirements for its design, co nstruction and detection.
阐述了小直径灰土挤密桩围箍技术处理既有建筑物湿陷性黄土地基的原理,通过在具体工程中的应用,提出了设计、施工、检验的具体方法及要求。
5) indentation method
压痕法
1.
The adhesion property of Au/NiCr/Ta multi-layered metallic films was investigated by the indentation method,rolling contact fatigue method and scratch method with both friction and acoustic emission modes.
针对Al2O3基体上磁控溅射沉积的Au/NiCr/Ta多层金属薄膜,用压痕法、滚动接触疲劳法、摩擦力和声发射两种模式同时监测的划痕法,对比研究了金属薄膜与基体的结合性能。
2.
The properties of thermal shock resistance of these two materials were also estimated by indentation method.
用压痕—强度法获得了Al2O3+ZrO2单层和层状陶瓷的表面抗裂纹曲线,用压痕法测试了2种材料的抗热震性能,分析了材料的表面抗裂纹行为、抗热震性与断裂形貌,强韧化之间的相关性。
3.
Fracture toughness of alumina matrix ceramics measured by indentation method and single edge notched beam specimen techniques were analyzed and contrasted, and the most suitable indentation method equation was confirmed.
用压痕法和单边切口梁法测量了氧化铝基陶瓷材料的断裂韧性,对这两种方法所测得的结果进行了分析对比,确定了最适用的压痕法计算公式。
6) indentation
[英][,ɪnden'teɪʃn] [美]['ɪndɛn'teʃən]
压痕法
1.
Contact damage of Ti3SiC2 under Vickers and Hertzian indentations was investigated to understand the energy-dissipation mechanism during the indentation loading.
采用维氏和赫兹压痕法研究了Ti3SiC2接触损伤及其演变。
2.
This paper deals with the evaluation of three different methods of K_(1c) determination, namely Aingle-Edge Notched Beam Three Point Bending (SENB), Indentation and Bridge Crack-Inducing (BI).
以单边切口梁三点弯曲法、直接压痕法和桥式预裂纹三点弯曲法对Al_2O_3——TiC复合陶瓷刀具材料进行了断裂韧性K_(1c)值的测试,结果表明,对这种微米级颗粒尺寸的陶瓷材料,切口梁法的结果与桥式预裂纹法接近,基本反映了真实K_(1c)值,切口的钝化作用不明显;压痕法的结果比其它两方法偏低。
3.
Elastic modulus and indentation stress strain curves were measured for different cases: (1) marble, mortar in water and 4%(vol) HCl for 5 min; (2) concrete in air, water and 5%(vol) HCl at the ages of 5,10,20,60, 90 d.
用Al2 O3球压痕法研究了砂浆、混凝土和大理石在空气、水和盐酸溶液中的压痕应力 应变关系和接触损伤演变规律 。
补充资料：箍围
1.方言。岛中的村落。因为水所环绕﹐故称。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条