说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 多项选择完形测试
1)  multiple-choice cloze test
多项选择完形测试
1.
The multiple-choice cloze test is a type of verbal communication.
多项选择完形测试是一种言语交际活动。
2)  multiple-choice reading comprehension tests
阅读理解多项选择测试
3)  MC listening comprehension tests
多项选择听力测试题
1.
This thesis“A retrospection study on the construct validity of multiple-choice (MC) listening comprehension tests”explores the construct validity of MC listening comprehension tests through examining the test-taking processes of test-takers.
本论文“多项选择听力测试题结构效度追述法研究”通过分析考生答题时的思维过程,探讨了多项选择听力测试题的结构效度。
4)  multiple choice test
多项选择题测验
1.
Supposing that the mark of the test equals the sum of the true mark and the conjectural one in a multiple choice test.
在多项选择题测验的卷面分数等于真实分数和猜测分数之和的假设模型下,给出了计量猜测因素影响程度(简称猜测度)的一种统计方法。
2.
In this pqper,under the hypothesis of Multiple Choice test score model that the test Score X is the sum of the true score T and the guessed score G,a theoretic formula about the reliability for Multiple Choice test is obtained,From this result ,a estimate method of the reliability is proposed.
在多项选择题测验分数等于真实分数和猜测分数之和的假设模型下,本文得到了一个多项选择题测验信度的理论公式,并由此给出了测验信度的估计方法。
5)  multiple-choice assessment
多项选择测定
6)  Multiple-Choice Cloze
多项选择完型填空
1.
A Comparative Study on Multiple-Choice Cloze and Open Cloze;
多项选择完型填空和开放式完型填空对比研究
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条