1) overburden pressure
表土层压
2) surface layer stress
表层应力
1.
Study on surface layer stress of small-diameter wood during drying process;
干燥过程中小径木表层应力的研究
3) Subsurface stress
表层应力
1.
Analysis of the Gear Subsurface Stress under the Transient EHL Condition;
基于瞬态弹流润滑的齿轮表层应力分析
4) surface pressure
表面压力
1.
Comparison of surface pressure characteristics of bulbous bows in different profiles through wind tunnel tests;
不同型线结构船艏表面压力特性对比实验研究
2.
Changes of surface pressure with adsorption time were determined at different protein concentration and pH.
采用轴对称滴形分析法研究了大豆11S球蛋白在空气-水界面上的吸附动力学,主要检测了不同浓度和pH值条件下表面压力随吸附时间的变化。
3.
A figure for the surface pressure distribution at 0-deg yaw angle is also given.
通过对典型客车模型风洞试验过程、方法以及试验数据的分析介绍,给出了客车模型在60m/s风速时,气动阻力系数随横摆角的变化关系曲线,零横摆角时的表面压力分布。
5) Pressure gauge
压力表
1.
Analysis on indeterminate degrees of the test result of 1.6 stagge pressure gauge;
1.6级工作压力表测量结果不确定度分析
2.
Optimum design of the parameters in pressure gauge s mechanism;
压力表机构参数优化设计
3.
Design and implementation of fully automatic calibration system for pressure gauges with pointers
指针式压力表自动检定系统的设计与实现
6) pressure meter
压力表
1.
This paper introduces a new method for realizing the remote measuring,remote controlling and alarm through remanufacturing the needle manometer into the remote intelligent pressure meter,and introduces the hardware and software design of single chip computer system and the development and relative application of the corollary electronic monitoring system.
阐述了将指针式压力表改制成单片机控制的远程智能压力测量表以实现遥测、遥控与报警的方法,介绍了单片机系统的硬件及软件设计,分析了与之配套的电子监控系统的开发及其应用。
2.
The structure design of the key parts such as grease pump and the pressure meter was pointed out.
针对饲料机械采用人工加脂润滑存在的弊端,研究了自动集中润滑系统的工作原理及技术方案,提出了干油泵和压力表等关键部件的结构设计方法。
补充资料：轧辊残余应力(见轧辊应力)
轧辊残余应力(见轧辊应力)
residual stresses in roll
zhagun eanyu yingli轧辊残余应力(residual stresses in roll)见礼辐应力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条