说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 镍、钼含量
1)  nickel and molybdenum content
镍、钼含量
1.
Effects of nickel and molybdenum content on microstructure and properties of low carbon high alloyed steel;
镍、钼含量对低碳高合金钢组织和性能的影响
2)  nickel-molybdenum ore with carbon
含碳镍钼矿
3)  molybdenum content
钼含量
1.
A series of 27%Cr high chromium cast irons with different carbon and molybdenum contents were made for microstructure and hardness inspection and abrasion resistance testing.
对不同碳、钼含量的27%高铬铸铁的组织、硬度及耐磨性等进行了试验。
2.
The molybdenum content of the h.
对中国东部华北克拉通南缘(山东临朐、昌乐、胶州和安徽明光)和华南地块(福建牛头山、广东英峰岭、海南定安和海南蓬莱)80件地幔岩包体及其寄主玄武岩石中的钼含量进行了分析。
3.
In addition,the cermet with less molybdenum content will provide a better thermal shock resistance than that with higher molybdenum content.
结果表明,随着热震温度的升高和热循环次数的增加,金属陶瓷中的裂纹增长;钼含量较低的Ti(C,N)-Co金属陶瓷抗热震性能较好。
4)  content of nickel
镍含量
1.
The content of nickel in soils of Hainan province ranges from 0 74 to 178 31 mg/kg, the average content 20 32 mg/kg.
海南省地处热带地区,土壤镍含量为0。
5)  nickel content
镍含量
1.
Determination of nickel content in Fe~(2+),Ni~(2+) solution;
二价镍和二价铁溶液中镍含量的测定
2.
This article reports the effect of the nickel contents in the raw materials on the synthesis of Mg_2NiH_4 by hydriding combustion and the various dehydriding temperatures of different hydrides.
报道了原料中不同镍含量对氢化燃烧合成Mg2NiH4的影响和生成物中各氢化物的放氢温度等相关研究。
3.
The spectrophotometric method follows beer's law provided that nickel content is in the range of 0 to 200 mg, which is accurate an.
该法在镍含量为 0~ 2 0 0mg范围内遵守比耳定律 ,测量结果准确 ,能满足实际生产的要
6)  Ni content
镍含量
1.
It was valuable to decrease the amount of Fe-Cr-Ni phase by increasing Ni content.
结果表明,由于大量析出铁铬镍合金相导致了此钢种的伸长率不合格;提高镍含量能有效降低铁铬镍相的析出,从而提高伸长率的合格率。
2.
The Ni content was detected by digestion with aqua regia-perchloric acid and using(ICP-OES).
对河南省分布的主要土类耕层土壤100个土样抽样调查,分析测定了土壤类型、质地、有机质含量、pH值,并采用王水-高氯酸消解、电感耦合等离子体发射光谱仪对土壤样品中的镍含量进行了测定。
补充资料:钼钴镍催化剂
分子式:
CAS号:

性质:一种用于炼油的加氢精制催化剂。深蓝色。片状或1.2~2.5mm的小球状。堆积密度0.86~1.0g/cm3。氧化铝为载体。活性组分大致含氧化镍2.6%~3.2%,氧化钴1.3%~1.9%,三氧化钼15%~18%。活性高。反应温度低。稳定性好。强度高。寿命长。脱氮脱硫性能比钴钼和镍催化剂好。常用于汽油、柴油、煤油的加氢精制。常压柴油和减压柴油的加氢脱硫。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条