1) pressure angle
接触角度
1.
Using this testing system,the vibration responses of the shrouded turbine blade with different mounting tightness and pressure angles are measured.
为验证某型真实带冠涡轮叶片叶冠干摩擦阻尼减振效果,本文建立了可实现正压力连续调节的非旋转状态涡轮叶片试验系统,对不同接触紧度、不同接触角度的真实带冠涡轮叶片的振动响应进行了测试。
2.
The vibration characteristics and response of the shrouded blade with different mounting tightness and pressure angles were measured.
利用该试验系统,对不同接触紧度,接触角度带冠叶片的振动特性及响应进行测试,结果表明带冠叶片出现了共振频率分叉的非线性现象。
2) contact surface height of rock column
端角接触面高度
3) non-contact angle measurement
非接触角度测量
4) included angle
夹角接触角;坡口角度
5) contact angle
接触角
1.
Influences of surface tension of acid solution and contact angle of rock on the cleanup efficiency of surfactant;
表面张力和接触角对酸液助排率的影响研究
2.
Comparison of hypsometry and goniometry in contact angle measurement;
接触角测量的量高法和量角法的比较
3.
Surface free energy of basalt and glass fibers by contact angle method;
接触角法测玄武岩及玻璃纤维表面能实验
6) contact angle
接触角法
1.
The compatibility、thermal stability and hydrophilicity of PVA/PA-6 alloy were studied by relative viscosity、refraction index、DSC、FTIR、TG and the contact angle.
采用黏度法、折光指数法、DSC法、FTIR法、TG法和接触角法研究了PVA/PA-6的相容性、热稳定性及亲水性。
2.
Several surface analysis technic and its application fields were introduced,such as contact angle(CA), ATR/FT-IR,XPS and so on.
综述了接触角法(CA)、衰减全反射/傅里叶变换红外光谱法(ATR/FT-IR)、X射线光电子能谱法(XPS)等几种表面分析技术的特点和应用领域,结合聚氨酯(PU)衬层的特点,提出了适用于表征PU衬层表面特性的一些方法。
补充资料：Anglelapping角度研磨
angle lapping 的目的是为了测量junction的深度，所作的芯片前处理，这种采用光线干涉测量的方法就称之angle lapping。公式为xj=λ/2 nf即junction深度等于入射光波长的一半与干涉条纹数之乘积。但渐渐的随着vlsi组件的缩小，准确度及精密度都无法因应。如srp(spreading resistance prqbing)也是应用angle lapping的方法作前处理，采用的方法是以表面植入浓度与阻值的对应关系求出junction的深度，精确度远超过入射光干涉法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条