1) valve short circuit protection
阀短路保护
1.
This paper studies the influence of converter transformer D-bridge zero sequence circulating current on valve short circuit protection.
笔者研究了换流阀三角形侧零序环流对阀短路保护误动作的影响。
2) short circuit protection
短路保护
1.
Test and analysis of short circuit protection for IGBT inverter;
IGBT逆变器短路保护试验与分析
2.
Using voltage sampling to achieve short circuit protection can cover the shortages of current sampling which is widly used at present.
电压取样的短路保护方式,能克服现行的电流取样保护方式的不足。
3.
The chip has internal short circuit protection,open circuit protection,lightning strike protection and thermal shutdown protection circuits.
芯片内设的短路保护、开路保护、雷击保护、过温保护等电路可保证收发器在恶劣的应用环境下正常工作。
3) short-circuit protection
短路保护
1.
Design of short-circuit protection circuit for Li-ion battery piles;
锂离子电池组的短路保护电路设计
2.
Applied of short-circuit protection for the same circuit different voltage in the DC supply system;
同一电路不同电压等级直流供电系统中的短路保护实现
3.
The research of IGBT driving and short-circuit protection circuit;
IGBT驱动及短路保护电路研究
6) circuit protection valve
电路保护阀
补充资料:溢流阀、顺序阀、减压阀的比较
溢流阀 | 减压阀 | 顺序阀 | ||
控制油路的特点 | 通过调整弹簧的压力控制进油路的压力,保证进口压力恒定,p2=0 | 通过调整弹簧的压力控制出油口的压力,保证出口压力p2稳定 | 直控式-通过调定调压弹簧的压力控制进油路压力;夜控式-由单独油路控制压力 | |
出油口情况 | 出油口与油箱相连 | 出油口与减压回路相连 | 出油口与工作回路相连 | |
泄漏形式 | 内泄式 | 外泄式 | 内泄式 | |
进油口状态及压力值 | 常态 | 常闭(原始状态) | 常开(原始状态) | 常闭(原始状态) |
工作状态 | 进出油口相通,进油口压力为调整压力 | 进油口压力低于出油口压力,出油口压力稳定在调定值上 | 进出油口相通,进油口压力允许继续升高 | |
联接方式 | 并联 | 串联 | 实现顺序动作式串联作卸荷阀用时并联 | |
功用 | 定压、溢流或安全作用限压、稳压、保压 | 减压、稳压 | 不控制系统的压力,只利用系统的压力变化控制油路的通断 | |
进油腔压力p1控制阀芯移动 | 出油腔压力p2控制阀芯移动 | 进油腔压力p1控制阀芯移动 | ||
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条