1) Laser Ablation System(LAS)
激光熔样系统
1.
In order to improve the ablation precision,efficiency and the automation of Laser Ablation System(LAS) in Mass Spectrograph(MS),the intelligentization of laser ablation system was studied in MS by taking inert gas isotope-MS as an experimental subject.
完成了激光熔样系统中二维样品台的重新设计,石墨炉进样系统的自动化设计。
2) laser system
激光系统
1.
Amplification of hybrid-widen linewidth of broadband pulses in Nd:glass laser systems
混合加宽的宽带钕玻璃激光系统的放大特性研究
2.
Presenting a laser system generates suitable laser power for use in photodynamic therapy,the laser system generates a red laser at 660nm near the absorbing peak of second-generation photosensitisers,can treat malignant disease fast and efficient with output power greater than 4 watts.
基于光动力治疗的基本原理提出了一种治疗肿瘤的激光系统 ,输出 660nm红光波长位于光敏剂吸收峰附近 ,输出功率大于 4W能快速有效的治疗肿
3.
Based on the relative fluctuation C(0) of light intensity and signal-noise ratio (SNR) of the output of the single-mode laser gain system of input signal,the physical value K is defined to describe the overall output of the laser system.
根据输入信号的单模激光增益系统的光强相对涨落C(0)和输出功率信噪比SNR,定义了物理量K,以描述激光系统的整体输出性质。
3) MOPA laser system
MOPA激光系统
1.
In this paper,while obtaining the high beam quality laser seeder by the the method of twist mode,compensation of birefringence?design of uniform pump cavity and phase conjugation mirror(PCM) were used to improve the beam quality of MOPA laser system.
利用扭转模获取高光束质量种籽源的同时,进行了高功率二极管均匀泵浦聚光腔设计,研究相位共轭镜用于改善MOPA激光系统光束质量诸特性。
6) CPA laser chain
CPA激光系统
1.
The measured result in our 23 TW CPA laser chain was coincident with the one measured by Shack-Hartmann method.
本文设计并发展了基于三平板干涉的双环路波前剪切干涉测量装置,并应用于测量本实验室CPA激光系统各级放大器和压缩器输出的光束质量,测量结果与哈特曼方法进行了比较测量,得到了很多有意义的一致性结果。
补充资料：熔盐电解法生产铌粉(见熔盐电解法生产钽粉)
熔盐电解法生产铌粉(见熔盐电解法生产钽粉)
production of niobium powder by molten salt electrolysis
rongyand+onjlefa ShengChan n.fen熔盐电解法生产妮粉(produetion。fn;obi-um powder by molten salt eleetrolysls)见熔盐电解法生产担粉。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条