1) CPP-g-MAH
氯化聚丙烯接枝马来酸酐
1.
Studies on the Physical and Chemical Properties of Polymaleic Anhydried--By-product of CPP-g-MAH;
氯化聚丙烯接枝马来酸酐的副产物—聚马来酸酐物性的研究
2) chlorinated polypropylene grafted maleic anhydride copolymer
氯化聚丙烯-马来酸酐接枝共聚物
3) PP-g-MAH
马来酸酐接枝聚丙烯
1.
To improve the interfacial compatibility between wood fiber and polypropylene as well as the toughness of wood fiber-polypropylene composites,maleic anhydride grafted polypropylene(PP-g-MAH) and maleic anhydride grafted styrene-ethylene-butadiene-styrene copolymer(SEBS-g-MAH) were used as modifiers.
为了改善木纤维与聚丙烯之间的界面相容性,提高木塑复合材的刚度和韧性,该文利用马来酸酐接枝聚丙烯(PP-g-MAH)及马来酸酐接枝苯乙烯-乙烯-丁二烯-苯乙烯嵌段共聚物(SEBS-g-MAH)对其进行增强和增韧改性。
2.
PA6/PP alloy was prepared using PP-g-MAH as compatilizer, and the effects of varied content of PP-g-MAH and PA6/PP ratio on alloy properties were studied.
以马来酸酐接枝聚丙烯(PP-g-MAH)为增容剂,制备了PA6/PP合金,研究了PA6/PP配比及PP-g-MAH用量对PA6/PP合金性能的影响。
3.
PP-g-MAH/down powder blend films with different content of powder were obtained after down powder were pretreated by different kinds of plasticizers,and the influence of down powder content,the type of PP,and the kind of plasticizers on the mechanical properties of blend films were studied.
采用不同增塑剂对羽绒粉体处理,制备了不同羽绒含量的马来酸酐接枝聚丙烯(PP-g-MAH)/羽绒粉体共混膜,分析了粉体含量、PP种类及不同增塑剂对共混膜力学性能的影响。
4) maleic anhydride grafted polypropylene
马来酸酐接枝聚丙烯
1.
Influence of maleic anhydride grafted polypropylene on shear strength of adhesion bonded aluminum sheet/polypropylene/aluminum sheet;
马来酸酐接枝聚丙烯对铝薄板/聚丙烯界面粘接强度的影响
2.
Polypropylene (PP)/woodflour (WF) composites (WPC) was taken as research object to study the effects of content of woodflour and maleic anhydride grafted polypropylene (PP-g-MAH) on thermal properties of WPCs.
以聚丙烯(PP)/木粉(WF)复合材料(WPC)为对象,研究了WF及马来酸酐接枝聚丙烯(PP-g-MAH)含量对WPC热性能的影响。
3.
Wood powder converted into thermoplastic wood(TPW) though benzylated with phase transfer catalysis(PTC),which extruded and mixed into TPW/MAH-PP/Mica composite with maleic anhydride grafted polypropylene(MAH-PP) and Mica.
通过苄基化法在相转移催化剂(PTC)的作用下可将木粉制备成热塑化木材(TPW),然后将热塑化木材、马来酸酐接枝聚丙烯按一定比例配料后,再分别与不同质量的云母共混挤出,制备成热塑化木材/马来酸酐接枝聚丙烯/云母复合材料(TPW/MAH-PP/Mi-ca)。
5) PP-g-MAH
聚丙烯接枝马来酸酐
1.
Effect of PP-g-MAH on Mechanical Properties of PP/Attapulgite Composites;
聚丙烯接枝马来酸酐对聚丙烯/凹凸棒石复合体系力学性能的影响
2.
The compatibilization effect of PP-g-MAH on PP/PA6 blend was studied, and its effect on the mechanical properties of the blend was discussed.
研究聚丙烯接枝马来酸酐相容剂对聚丙烯／尼龙6体系的增容作用;并讨论了PP-g-MAH对PP／PA6共混物的力学性能的影响。
6) maleic anhydride graft polypropylene
马来酸酐接枝聚丙烯
1.
Effects of coupling agent(KH550) and maleic anhydride graft polypropylene(MPP) on the interface state and rheological properties of the polypropylene/glass bead(PP/GB) composite were stu-(died).
研究了偶联剂(KH 550)和马来酸酐接枝聚丙烯(M PP)表面偶联反应对聚丙烯(PP)/玻璃微珠(GB)复合材料界面形态和流变性能的影响。
补充资料：氯化聚丙烯
分子式：
分子量：
CAS号：
性质：简称CPP。聚丙烯分子链上引入氯原子的一种极性热塑性树脂。含氯20%-40%为低氯化度、含氯63%-67%为高氯化度。均为白色粉末或颗粒，但成膜后无色。熔点<150℃（氯含量30%者熔点最低），于180-190℃分解。不溶于乙醇及石蜡烃，溶于芳烃及酯类、酮类。耐油、耐热、耐光；能抗强氧化性酸及强碱的腐蚀，CPP膜能在10%苛性钠溶液或10%硝酸中浸渍144小时仍不溶胀。与大多数树脂如古马隆树脂、石油树脂、酚醛树脂、醇酸树脂、煤焦油树脂、松脂等相容性好。可用作粘接塑料与金属的胶粘剂、涂料载色剂、纸张涂层、防水剂、阻燃剂、印刷油墨添加剂等。可采用溶液法、悬浮法或固相法将聚丙烯氯化而制得。
分子量：
CAS号：
性质：简称CPP。聚丙烯分子链上引入氯原子的一种极性热塑性树脂。含氯20%-40%为低氯化度、含氯63%-67%为高氯化度。均为白色粉末或颗粒，但成膜后无色。熔点<150℃（氯含量30%者熔点最低），于180-190℃分解。不溶于乙醇及石蜡烃，溶于芳烃及酯类、酮类。耐油、耐热、耐光；能抗强氧化性酸及强碱的腐蚀，CPP膜能在10%苛性钠溶液或10%硝酸中浸渍144小时仍不溶胀。与大多数树脂如古马隆树脂、石油树脂、酚醛树脂、醇酸树脂、煤焦油树脂、松脂等相容性好。可用作粘接塑料与金属的胶粘剂、涂料载色剂、纸张涂层、防水剂、阻燃剂、印刷油墨添加剂等。可采用溶液法、悬浮法或固相法将聚丙烯氯化而制得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条