1) fibre volume content
纤维体积掺量
1.
3% fibre volume content were prepared.
为了研究玄武岩纤维混凝土(basalt fiber reinforced concrete,简称BFRC)的冲击力学性能,制备了纤维体积掺量分别为0、0。
2) fiber content
纤维掺量
1.
The variation between fiber content and compressive strength,splitting strength were analyzed.
为了研究纤维掺量对沥青混凝土强度的影响,选用5种纤维掺量沥青混凝土的马歇尔试件和圆柱体试件,在MTS810材料试验机上进行劈裂试验和单轴压缩试验,分析了劈裂试验结果和抗压强度随纤维掺量变化的规律。
2.
When the base strength grade is in the range of C30~C50,and thread steel fiber content is 0~1.
5%掺量范围内,对抗压强度的增强作用明显;当基体强度等级达到C60,纤维掺量在0。
3.
The viscoelastic performance was simulated by using four-unit five-parameter model,its parameters were obtained from the data of the test,and a four-unit five-parameter viscoelastic constitutive model with fiber content was set up.
根据粘弹性力学理论,采用"四单元五参数"模型(修正的Bugers模型)模拟纤维沥青混凝土的粘弹性能,其参数值由试验数据的数值拟合获得,提出了计入纤维掺量的"四单元五参数"粘弹性本构模型。
3) fibers content
纤维掺量
1.
It was found that the error is sensitive to temperature and fibers content.
Weng在Eshelby-Mori-Tanaka理论基础上提出的纤维增强复合材料的等效模量公式,计算了具有不同纤维掺量的纤维沥青混凝土在不同温度状态下的等效劲度模量,对计算结果与劈裂试验结果进行了比较和误差分析。
4) volume fraction
体积掺量
1.
Three fiber lengths:3mm,6mm and 10mm and fiber volume fractions ranged from 0.
在正交试验的基础上,采用NEL试验方法研究了不同掺量(体积掺量0。
2.
The effect of water-cement ratio,steel-fiber volume fraction and steel-fiber length-diameter ratio on flexural strength of steel-fiber reinforced high performance concrete is investigated.
选用钢板剪切异形钢纤维,在钢纤维平均长度相近的条件下,研究基体水灰比、钢纤维体积掺量、钢纤维长径比对钢纤维增强混凝土抗弯强度的影响,并结合了试验设计中选取的因素和水平构成的立方体图形进行分析。
5) fiber volume fraction
纤维体积含量
1.
Structural characteristics of orthogonal binding weave and their effect on the fiber volume fraction of reinforcement;
正交接结组织结构特征及其对纤维体积含量的影响
2.
Theoretical Analysis of Fiber Volume Fraction in Synthetical Sleepers
合成枕木纤维体积含量的理论分析
3.
The methods for determining the fiber volume fraction in carbon fabric reinforced composite laminates were developed by using the processing and analyzing techniques of section images of laminates, which are sampled by the use of CCD camera and A/D device.
利用CCD摄像机和专用A/D板采集的碳纤维织物增强的复合材料层合板截面图像检测碳纤维机织物增强复合材料的纤维体积含量。
6) fibre volume fraction
纤维体积含量
1.
In this paper, the relation between fibre volume fraction and stress concentration around the hole was studied,which was based on an example that symmetric fibre-reinforced laminates contains a single hole under plane loading .
纤维体积含量是决定纤维增强复合材料各项力学性能的一个重要参数。
2.
This paper discussed the effects of fibre volume fraction on performances of C/C composite through the sample tests of various fibre volume fractions.
通过对不同纤维体积含量的炭／炭复合材料进行力学性能、导热、导电性能试验，分析了纤维体积含量对炭／炭复合材料性能的影响。
3.
In this paper, the relation between fibre volume fraction and tensile properties of ployamide 6 tyre cord/nature rubber was studied by theoretical analysis and experiment.
纤维体积含量是决定纤维增强复合材料各项力学性能的一个重要参数。
补充资料：掺掺
1.女手纤美貌。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条