1) mold loading
按发泡涨大率装模
2) expansion rate
涨发率
1.
Effect of hardness of water on the expansion rate of sea cucumber
水的硬度对海参涨发率的影响
3) foaming device
发泡装置
4) foaming rate
发泡速率
1.
Effects of such factors as formaldehyde-to-phenol molar ratio,manufacturing temperature were studied to investigate how they influenced the curing and foaming rate.
提出了一种在石蜡油浴中搅拌状态下制备中空酚醛微球的新方法,研究了甲醛苯酚单体配比、制备温度对固化速率与发泡速率的影响。
5) foamability
发泡倍率
1.
When the amount of foaming agent was 15% and the content of silicone AK8805 was 9% the foamability of the foaming system could reach 43.
当发泡剂含量为15%、有机硅AK8805的含量为9%时,该发泡体系的发泡倍率可达到43。
2.
The effects of the content of foaming agent as well as the kinds and content of foam stable agent on the foamability and the adhesion strength were investigated.
以环氧树脂和丙烯酸为基本原料,合成环氧丙烯酸酯,采取氧化还原引发方式,用环氧丙烯酸酯及其它活性单体和添加剂制备出一种室温快固型发泡胶粘剂;考虑了发泡剂用量、泡沫稳定剂种类及用量对发泡倍率和粘接强度的影响。
6) expansion ratio
发泡倍率
1.
The expansion ratio had a small drop as the temperature increased.
研究发现,发泡工艺对体系发泡倍率有较大影响;随温度升高发泡倍率略有降低;成核剂滑石粉和发泡助剂尿素的加入使淀粉和淀粉/PVA共混体系的发泡倍率都呈先增大后减小的趋势。
2.
In the paper,with Taguchi experiment design method and BP(Back Propagation) neural network technology,the effects of four factors,molding temperature,molding time,injection pressure,and molding pressure on the expansion ratio of foamed ethylene-vinyl acetate copolymer(EVA) were studied with a four-level orthogonal experiment.
采用田口实验设计方法与BP神经网络技术,选取模具温度、模压时间、注射压力和模压压力四因素四水平安排正交试验,分析了工艺参数对乙烯-醋酸乙烯共聚物(EVA)塑料发泡倍率的影响程度。
补充资料：装模做样
也作“装模作样”。为了表现自己，故意作出一种样子或做作：装模做样，讨大家的称赞。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条