1) turn-in point

攻击转弯点
2) Re-aiming

多点攻击
1.
Simulation Research of the Command Model Supporting the Function of Re-aiming of the Low Observable Aircraft;
能实现多点攻击的巡航导弹指挥模型研究
3) characteristics of attacking

攻击特点
4) attack sb. by name

点名攻击
5) node attack

节点攻击
1.
In this paper,a safety program to identify is brought forward based on symmetric key algorithm,the key issue way’s improvement met the broadcasting hardware security identification in ubiquitous computing environment,and the μTESLA’s avoids the node attack because of time synchronization errors.
给出一种基于对称密钥算法的安全鉴别方案,通过对密钥发布方式的改进,满足普适计算硬件环境的广播安全鉴别,对μTESLA进行改进,避免了其由于时间同步错误导致的节点攻击。
6) attack points

攻击点
1.
According to traditional linear regression analysis technique fitting existence problem of attack points of guided-bomb,the paper presents a new method of back propagation neural network algorithm(BP) which fit attack points of some guided-bomb was proposed.
针对目前用传统的线性回归等方法拟合有控炸弹攻击点所存在的问题,文中提出了采用BP神经网络算法对某有控炸弹的攻击点进行拟合的新方法。
补充资料:闭式单点、双点压力机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB10924-89、GB10933-89、JB5200-91 | ||||||
1、滑块下平面对工作台上平面的平行度(mm) | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.02+0.10/100×滑块下平面的被测长度 | |||||||
2、滑块行程对工作台上平面的垂直度 | 30%精度储备 | 20%精度储备 | 达到规定值 | 大于规定值 | |||
0.05+0.02/100×滑块行程长度 | |||||||
(二)结构性能 | |||||||
1、离合器、制动器接通率,当滑块行程次数≤16次/分时为70%,≤25次/分时为60%,≤45次/分时为50% | 大于规定值10% | 大于规定值 | 达到规定值 | 达不到规定值 | |||
2、液压超负荷保险装置、微调装置、吨位指示器 | 全部具有 | 全部具有 | 部分具有 | 没有 | |||
(三)噪声dB(A) | |||||||
1、公称力≤400kN | ≤85 | ≤87 | ≤88 | >88 | |||
2、公称力>400kN | ≤87 | ≤88 | ≤90 | >90 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条