1) cutting sequence
剪裁循环
2) cyclic simple shear
循环单剪
1.
In this paper,the cyclic simple shear tests of the saturated soil of saturation 95 %,92 %,88 % and 83 % were carried out under the consolidation pressure of 50 kPa,100 kPa and 200 kPa respectively.
在50,100,200 kPa三种固结压力下分别对饱和度为95%,92%,88%,83%的饱和土样进行了循环单剪试验,得到了4种土样在3种固结压力下的最大动剪模量Gdmax和最大阻尼比Dmax,以及动剪模量比G/Gdmax-γ和阻尼比D/Dmax-γ归一化数值,并进行了对比分析。
2.
The cyclic simple shear tests of the saturated soil with saturation 95%,92%,88% and 83% were carried out under the consolidation pressure of 50 kPa,100 kPa and 200 kPa,respectively.
在50kPa、100kPa和200kPa 3种固结压力下分别对饱和度为95%、92%、88%和83%的土样进行了循环单剪试验,得到了该土样在4种饱和度、3种固结压力下的最大动剪模量Gdmax以及动剪模量比G/Gdmax-γ归一化曲线。
3.
Furthermore,undisturbed samples of each layer soil are taken out,and the maximum dynamic shear modulus is obtained by laboratory cyclic simple shear tests.
此外,取出了场地各层土的原状土样,进行了室内循环单剪试验,获得了各层土的动剪模量,并与剪切波速的计算结果进行了比较分析。
3) cyclic shear
循环剪切
1.
A comparative study on monotonic and cyclic shear behavior of saturated loose sand under complex stress condition;
复杂应力条件下饱和松砂单调与循环剪切特性的比较研究
4) cyclic torsion shear
循环扭剪
5) thermal-shearing cycling
热剪切循环
1.
Growth behavior of compounds formed at Sn-3.5Ag-0.5Cu/Cu and Sn-Pb/Cu interfaces during thermal-shearing cycling;
SnAgCu/Cu和SnPb/Cu界面热剪切循环条件下化合物的生长行为
2.
5Cu /Cu interface after thermal-shearing cycling was investigated.
研究了热剪切循环条件下Sn-3。
6) thermal-shearing cycling
热-剪切循环
1.
In this paper,the atoms diffusion and growth behavior of intermetallic compounds(IMCs) on the Sn-Ag-Cu/Ni and Sn-Ag-Cu/Cu interfaces under the thermal-shearing cycling condition were investigated.
对热-剪切循环条件下Sn-3。
补充资料：循环系统的进化环节动物的封闭式循环系统
李瑞端绘
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条