1) volume elasticity
体积弹度
3) voluminal resilience
体积回弹
4) bulk viscoelasticity
体积粘弹性
5) Bulk density
体积密度
1.
Influence of bulk density and graphitization degree on hardness of C/C composites;
C/C复合材料的体积密度和石墨化度对硬度的影响
2.
The results show that both magnesia and spinel are good additives to improve sintering of alumina,and bulk density of the sample can also be increased by properly extending sintering holding time.
结果表明,适量氧化镁和镁铝尖晶石都能有效改善Al2O3陶瓷烧结性能,适当延长保温时间有利于样品体积密度的增加,但是掺杂微量氧化镁更有利于透过率的提高。
3.
The influence of hydroxyethyl methyl cellulose and vinyl co-polymer on the bulk density and capillary water absorption of hardened cement mortars was studied.
研究了羟乙基甲基纤维素和乙烯基共聚物2种聚合物干粉对硬化水泥砂浆体积密度和毛细孔吸水率的影响。
6) apparent density
体积密度
1.
Aiming at the unsatisfactory apparent density of green anode,this thesis figured out the disfigurement of dry aggregate recipe in a certain company,and took some effective steps to gain a higher apparent density,thus improved the quality of pre-baked anode.
针对生阳极制造过程中体积密度始终不理想的现状,通过分析、试验,发现干料配比中存在的问题,并采取有效措施,成功地提高了生块体积密度,从而明显提高了预焙阳极质量。
2.
A test is done on pre-baked anode made from calcined coke in aspects of apparent density,real density,porosity,resistivity of powder,compressive strength,which shows compressed petroleum coke improves its chemical and physical performances.
将煅前石油焦压密和煅烧,通过体积密度、真密度、显气孔率、粉末电阻率、颗粒抗压碎强度的测试,研究压密煅烧石油焦特性。
3.
The investigations were conducted experimentally on not only its petrogrphic structure but alsothe properties of its compressive strength, apparent porosity,apparent density and moisture content.
报道了玻璃－云母多孔材料研制的结果，研究了该材料的岩相结构，对材料的抗压强度、显气孔率、体积密度进行了测试。
补充资料：体积结晶度
分子式：
CAS号：
性质：采用结晶高聚物中晶区的体积百分数来表示的结晶度。×100％(式中V表示体积，下标c表示结晶，a表示非晶)。可采用密度法来测定。体积结晶度是衡量聚合物材料中分子链有序程度的参数，在聚合物的晶态结构同物理性能关系的研究中占有十分重要的地位，同时也是聚合物材料加工成型工艺中所需要的一个重要指标。
CAS号：
性质：采用结晶高聚物中晶区的体积百分数来表示的结晶度。×100％(式中V表示体积，下标c表示结晶，a表示非晶)。可采用密度法来测定。体积结晶度是衡量聚合物材料中分子链有序程度的参数，在聚合物的晶态结构同物理性能关系的研究中占有十分重要的地位，同时也是聚合物材料加工成型工艺中所需要的一个重要指标。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条