1) grindability factor
易磨性系数
2) erosive index
可磨性系数
3) vulnerability factor
易损性系数
4) grindability
[,ɡraində'biliti]
易磨性
1.
Started with clinker composition and structure, the grindability of Portland cement clinker is studied as well as the influencing factors in order to improve grindability of Portland cement clinker from the angel of clinker preparation technics.
从硅酸盐水泥熟料的组成与结构入手,研究探讨了硅酸盐水泥熟料的易磨性及其影响因素,以期从熟料制备工艺的角度,改善硅酸盐水泥熟料的易磨性。
2.
Bond law experiment was made for the raw meal grindability in certain cement factory and showed that this raw meal belonged to " moderately grindable ".
Bond)法对某水泥厂生料进行易磨性试验,结果表明该生料属于中等易磨物料。
3.
The grindability test has a moderate range of degree of fineness and departure fro.
易磨性试验存在一个适宜的细度范围 ,偏离这一范围就有可能导致粉磨功的大量消耗。
5) coefficient of rock abrasiveness
岩石磨蚀性系数
1.
Main influ-encing factors on rock abrasiveness are the sturdiness of rock mass and contentof hard minerals,and the coefficient of rock abrasiveness is a function of thespecific energy consumption in drilling and the content of hard minerals.
岩石磨蚀性系数是凿碎比功和硬矿物含量的函数,此结果已由模拟实验和实际凿岩试验所验证。
6) wear coefficient
磨损系数
1.
PR MMCs has super wear resistance with lower wear coefficient than high-speed steel.
复合材料比高速钢的磨损系数低两个数量级,具有更低的磨损系数,因此具有良好的耐磨性。
2.
In this paper, how to select wear coefficient X for blanking die work size was analyzed, And the new way of wear coefficient calculation was worked out, And through some examples, explain how to use it.
分析了在冲裁凸、凹模工作尺寸计算时 ,选取磨损系数X时存在的问题 ,提出了正确选取和计算磨损系数的方法 ,从而为凸、凹模工作尺寸的准确计算提供了保证 ,并举例进行了说明。
3.
According to test data of coatings obtained using home-made multifunctional micro-wear tester,the influence of crater measurement error on wear coefficient under line condition was mainly analyzed.
本文利用自行研制的多功能微磨损试验机研究涂层的微磨损测试数据,主要分析了线接触工况下磨痕的测量误差对磨损系数误差的影响,讨论了获得合理而准确的测量值的微磨损测试条件。
补充资料：连续性与非连续性(见间断性与不间断性)
连续性与非连续性(见间断性与不间断性)
continuity and discontinuity
11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt，n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条