1) tool height gage
高度对刀规
2) knife height
装刀高度
1.
The result showed that veneer thickness is always less than or equal to veneer nominal thickness, and variation of veneer thick- ness is influenced by knife height, veneer nominal thickness and instantaneity radius of the log.
从理论上探讨了旋切过程中单板厚度的变化规律，结果表明：单板厚度总是小于或等于单板名义厚度，其变化与装刀高度、名义厚度及木段瞬时半径有关。
3) diagonal metric
对角度规
1.
Under the diagonal metric and harmonic coordinate conditions, the fact that neither gravitational radiation nor gravitational waves exist are proved in this paper.
证明了在对角度规谐和条件下，不存在引力辐射和引力波，并对Ｂｏｎｄｉ引力平面波和引力孤立波进行了讨论。
2.
In this paper, the gravitational wave equations in the Vierbein representation of Einstein gravity under the diagonal metric and harmonic coordinate conditions are obtained, and some special cases are discussed.
本文在Ｖｉｅｒｂｅｉｎ表述的局域Ｌｏｒｅｎｔｚ群引力规范理论框架内，给出了谐和条件下的对角度规引力波方程，并对一些特殊情况进行了讨论。
3.
The general covariant expressions of the power flow density and total radiation power ofgravitational wave of diagonal metric are given in this paper.
给出了广义协变的对角度规引力波的功率流密度和辐射总功率表达式。
4) vernier height gage
高度规
5) unsymmetric angular milling cutter
不对称角度铣刀
6) relative height
相对高度
1.
The deformation mechanism of the part and the relationship between drawing factor and relative height were deduced.
通过对椭球底直筒形件的拉深过程进行应力应变分析,推出该类零件的变形机理,得出该类零件成形的拉深系数和相对高度的关系,并通过试验进一步验证其正确性。
2.
The change in the specific roll pressure of workblanks is investigated as the tool surface roughness and the relative height of workblanks are changed.
文章通过几个不同尺寸坯料在不同表面粗糙度的工具上进行的压缩试验 ,模拟金属锻造的变形过程 ;分析了坯料的不同几何尺寸与摩擦状态对锻造变形力及变形过程的影响 ;探讨了具有不同表面粗糙度的工具和相对高度毛坯 ,在变形时单位压力的变化情况 ;并就试验结果结合实际生产中的具体情况 ,讨论了锻造成形中的几个问题。
3.
Groundwater level is one of the most important factors to determine the relative height of pavement subgrade in soft soil area.
软土地区低路堤路基相对高度的确定,地下水位是主要因素。
补充资料：装聋装哑
1.见"装聋作哑"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条