1) fine cooling hole
细冷却孔
2) cooling hole
冷却孔
1.
Design and calculation of middle/low pressure fire pump′s cooling hole;
中低压车用消防泵中压室冷却孔的设计与计算
2.
In order to have an insight into the flow structure and the mechanism of vortex generation nearby cooling holes, the localized flow structure of rectangular jet holes perpendicular to a flat plate was numerically investigated.
为了深刻认识冷却孔附近的流动结构和旋涡生成机理,本文数值研究了平板上不同矩形射流孔附近的局部流场。
3.
By modeling the rotor blade of gas engine turbine,the influence of the position,shape(circle and rectanglar),size and number of cooling holes on thermal stress and cooling effect of turbine blade were investigated.
以某航空发动机涡轮转子叶片为原型,分析了冷却孔的位置、形状(圆形和四边形)、大小和数量对热应力与冷却效果的影响。
3) porous cooling
多孔冷却
4) spray cooling
精细冷却
1.
In flatness control of cold rolling mill, spray cooling control is usually used to correct higher flatness defect pattern A new spray cooling control system is given.
在冷轧带钢的板形控制中 ,轧辊精细冷却用来消除复合浪形即高次板形缺陷。
2.
An overview about the control technology of asymmetric higher order flattness in cold rolling mill was introduced,and the structure,characteristic and control requirement of spray cooling were also given.
介绍了冷轧机组不对称高次浪形的控制技术,以及轧辊精细冷却的组成、特点和控制要求。
5) film-cooling hole
薄膜冷却孔
6) coolant port
冷却液孔口
补充资料：第二孔(继发孔)型缺损
第二孔(继发孔)型缺损
ostium secondary defect
是心房间隔在形成上发生障碍，一般缺损较大，多在卵圆孔附近称第二孔(继发孔)型缺损。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条