1) ground arc

接地电弧
2) arc ground

接地弧,对地电弧放电
3) arcing grounding overvoltage

电弧接地过电压
1.
Marked advantages of damping resistor-both falling the probability and decreasing amplitude of overvoltage were pointed out by simulating and analyzing the circuit describing single phase arcing grounding overvoltage.
介绍了三相五柱式消弧线圈的工作原理,单相电弧接地过电压的工频熄弧理论。
4) intermittent arcing ground

电弧放电接地
5) arcing fault

电弧接地故障
1.
The authors analyze a lot of experimental data from the simulation of 6kV power network; obtain the features of zero-sequence transient currents in faulty feeder arcing fault and healthy feeders while arcing fault occurs.
作者分析了6kV模拟电网的大量实验数据,得到电弧接地故障时故障线路与非故障线路零序暂态电流的特征。
2.
To solve above problems,the paper proposed a single-phase grounding protection method that needs not zero-sequence voltage transient component and needs not calculate frequency and phase of transient component combing with lots of experiment data of simulated arcing fault of 6 kV power networks and analyzed implementation principle of the method in details.
针对上述问题,文章结合大量的6 kV电网模拟电弧接地故障实验数据,提出了一种不需要零序电压暂态分量、不需计算暂态分量频率和相位的单相接地保护方法,详细分析了该方法的实现原理。
6) arc grounding over-voltage

弧光接地过电压
1.
Simulation of PF arc grounding over-voltage based on MODELS

基于MODELS的工频弧光接地过电压的仿真
2.
Mechanisms of arc grounding over-voltage and ferroresonance over-voltage in insulated neutral systems are expatiated.
首先,阐述了配网中性点不接地系统产生弧光接地过电压和铁磁谐振过电压的机理,针对2种过电压的产生机理,提出采用氧化锌非线性电阻限压器投于系统故障相。
补充资料:电力系统弧光接地过电压
电力系统弧光接地过电压
arcing ground overvolt-age in electrical power system
d一onll xl士ong huguong}led一guod一onya电力系统弧光接地过电压(arcing groundovervoltage in eleetrieal power system)中性点不直接接地系统中一相接地将使另两相对地电容通过电源电感再充电而产生的过电压。接地电弧熄灭后,它们多余的电荷将通过电源电感对原故障相对地电容释放、再加上该相的电源电压,在其上产生恢复电压。上述过程如在不利条件下多次重复,三相对地及中性点位移电压均可能较高。由于随机的影响因素多,即使按简化的集中参数等值回路,一些重要参t的计算仍过于繁难,过去的一些理论分析,在电弧嫩、熄灭时刻的选择,中性点位移与恢复电压的关系诸方面.均有一些牵强的假定,其实用意义较小.根据实测及近来的研究,有关的结论是:①如原故障相绝缘强度只是瞬刻下降,其恢复电压与两正常相对地过电压相近;②以10kV系统为例,实测到的最大过电压为4.3倍相电压,对非弱绝缘无危险,③如熄弧时无截流,则相间与相对地过电压基本持平。 以往的研究工作对接地电流重视不够,原则上它应有:中性点电压突变及两正常相对地电容再充电的过渡过程所决定的电流;故障相对地电容原有电荷的释放及稳态的工频接地电流等分量。在中性点绝缘以及经消弧线圈接地的系统第一次接地时.实测到的短路电流脉冲的峰值均有数百安之多(可以想见,如电弧重燃、则电流值将更大),如接地点靠近变电所母线,则此持续时间虽短,但较强烈的电弧即可能波及到邻相,造成烧母线间隔的重大事故。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条