2) service restoration
供电恢复
1.
Multi-objective service restoration in distribution network considering load varying and overload ability of equipments;
考虑负荷变化和设备过载能力的多目标配网供电恢复
2.
This paper proposed a new algorithm for service restoration of distribution systems which is based on layered power supply tree.
为提高供电恢复速度,将问题分为离线计算和在线计算两部分,通过离线计算所得到的数据可以减少在线计算时的搜索空间,提高了在线计算的搜索速度,有效满足了供电恢复的实时性。
3.
In terms of the distribution system with distributed generations (DGs) especially considering the operation of micro-grids (MGs) composed of DGs and loads, a service restoration model aiming at the restoration of the most load with the least number of switching actions is built.
针对含分布式电源的配电系统,特别在考虑了由分布式电源和负荷组成微网运行的情况下,建立了以恢复负荷最多、开关操作数最少为目标的供电恢复模型。
3) power service restoration
供电恢复
1.
In this paper, A method to find power service restoration paths fastly named basic circuit is proposed.
提出了一种用于快速寻找供电恢复路径的方法——基本回路法,该方法首先对配电网络进行拓扑变换,然后求出其最小生成树,既而求得基本回路,利用基本回路可快速地确定故障元件隔离后的所有可能的恢复供电路径,在给定的目标函数和约束条件下,可以方便地求出最佳供电恢复方案,对杨明皓,黄单舸文中的例子进行了验证,计算结果表明了该方法的有效性。
2.
The first order moment algorithm of nodal load for real-time power service restoration of distribution network is proposed.
提出了适用于实时控制的配电网供电恢复计算方法——节点一阶负荷矩法。
4) service restoration
恢复供电
1.
This paper proposes a method to determine the service restoration strategies for affected load due to fault on a feeder line.
提出一种在电力线路故障后，为受故障影响停电的非故障区段负荷恢复供电的方法。
5) recovery gas supply
恢复供气
1.
The article discusses earthquake destruct gas system characteristic,mechanism combined with WenChuan earthquake and previous cases about recovery gas supply problems.
文章根据汶川大地震后都江堰及崇州在恢复供气中遇到的问题,结合往常的地震案例,对地震造成城市燃气系统破坏的特点、机理进行了简要的论述,从防震减灾的角度反思城市燃气系统的设计施工进程和震后的应急措施,提出了相关建议。
6) recovery stress
恢复应力
1.
The study results of the shape memory property of the film after annealing and crystallization show that the film has 180 MPa of maximum recovery stress and 2.
5 h晶化处理后无残余塑变存在下的最大恢复应力、最大恢复应变分别为180 MPa、2。
2.
The constraint transformation behavior of 7% strained TiNi alloy was investigated, and the experimental results show that the recovery stress formed at the first constraint transformation thermal cycling is the highest, and then decreases with increasing the constraint transformation thermal cycling number.
研究了预变形TiNi合金应变约束态下的相变行为,结果表明:7％应变TiNi合金变形后第1次应变约束相变产生的恢复应力最大,逆相变开始温度A_s′(2)最高,随着约束相变循环次数的增加,合金中引入大量塑性变形,降低了TiNi合金的恢复应变,进而造成TiNi合金约束相变恢复应力最大值逐渐降低,但约束逆相变开始温度A_s'第2次相变循环开始,几乎恢复到合金变形前的原始值,且不随相变循环次数增加而改变。
补充资料：用电人有要求供电人安全供电的权利
用电人有要求供电人安全供电的权利：用电人有要求供电人按照国家规定的供电质量标准和合同约定安全供电，这是供电人的主要义务，也是用电人的主要权利。供电人的供电质量标准包括电压频率、电压、供电可靠性须符合国家规定和约定的标准。供电的方式、时间、地址、和电量等须符合合同的约定。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条