1) cloudy formation
云彩状组织
2) cloud box
云彩组织检查箱
3) cloud box covering
云彩组织检查箱箱盖
4) zonal structure
带状组织
1.
In this paper,the mechanism of formation of zonal structures in low-carbon alloy steel and three methods for removing them are introduced.
介绍了低碳合金钢中带状组织形成机理及三种主要的消除或减轻的方法。
2.
The results revealed that the non homogeneous distribution of the carbide caused the “zonal structure” appeared in the joint of drill rod which is hardened and hightemperature tempered.
结果表明，碳化物分布不均匀导致调质处理后在钻杆接头中产生“带状组织”。
5) banded structure
带状组织
1.
Effect of Banded Structure in Low Carbon High Sulphur Free Cutting Steel on Crack Formation of Cold Drawn Products;
低碳高硫易切削钢带状组织对冷拔材裂纹形成的影响
2.
Formation and elimination of banded structure of 20CrNi2Mo steel;
20CrNi2Mo钢带状组织的形成与消除
3.
The effect of finishing rolling temperature on banded structure of 16Mn steel plate;
终轧温度对16Mn钢板带状组织的影响
6) lamellar structure
片状组织
1.
The results show that fatigue strength of bi-modal structure is higher than lamellar structure in the low cycle region.
研究了TA15钛合金片状和双态两种典型组织对疲劳性能和断裂韧度的影响,结果表明:在S-N曲线的高应力区,双态组织的疲劳强度高于片状组织;在低应力区,情况则相反,且片状组织的疲劳极限(656MPa)高于双态组织(565MPa)。
补充资料：设备安装前的准备工作——机械的开箱检查与清洗
| 设备安装前的准备工作——机械的开箱检查与清洗 | ||
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条