1) measured parameter
实测参数
1.
3 unit in Ankang Hydropower Plant are configured according to the measured parameters for excitation system,and its phase characteristics is verified by MATLAB software.
因此,在安康水电厂3号机励磁系统实测参数的基础上,配置整定了电力系统稳定器(PSS)各环节参数,并用MATLAB对其相位补偿环节进行仿真验证。
2) multi-parameters real-time monitoring
多参数实时监测
3) Real-time fault detection parameter
实时故障检测参数
4) real-time parameter
实时参数
1.
The application of MES in the production balance,the optimization of real-time parameter and correlation parameters,the calculation of accssory materials and etc.
介绍了MES在聚氯乙烯生产中乙炔站、氯乙烯、聚合各工序的生产平衡、实时参数及关联参数优化、辅助材料的核算等应用情况。
5) experimental parameters
实验参数
1.
The method of combination of experimental parameters with compu.
采用实验参数与计算机模拟相结合的建模方法,不必考虑除霜时翅片管内部的热交换,简化了计算,同时保证了模型的可靠性与精度。
2.
For the first time, the function relation formulae between the intensity of preferential orientation of the films and experimental parameters (such as sputtering pressure, target power and the distance) were found.
反应溅射制备ＡｌＮ 薄膜时，薄膜的择优取向与众多的实验参数有关。
3.
The results show that the design of the system is reasonable,and its product is uniform in granularity by adjusting the experimental parameters,which is suitable for the ultrafine grinding and classification requirements for the material for which the mohs hardness is below the middle grade.
实验结果表明:该系统设计合理,通过调节实验参数,产品粒度均匀,适合中等硬度以下物料超细粉碎分级要求。
6) compaction parameter
压实参数
1.
Subgrade compaction parameters of foreign countries and engineering significance;
路基压实参数及其工程意义
2.
Determination of compaction parameters of clay-core dam of Ni erji Reservoir;
尼尔基水利枢纽工程心墙坝粘性土料压实参数的确定
3.
Through the test of solidified blow sand characteristics, based on the experimental road practice of base course construction of Tonglian Road, the compaction parameters and construction technologies of blow sand are studied.
通过对固化风积沙工程特性的试验,结合通连公路固化风积沙基层试验路的工程实践,研究了固化风积沙的压实参数以及施工工艺。
补充资料：多苯基多亚甲基多异氰酸酯
多苯基多亚甲基多异氰酸酯，简称PAPI，或称粗MDI，浅黄色至褐色粘稠液体．有刺激性气味。相对密度(20℃／20 ℃)1．2，燃点218℃。PAPI实际上是由50％MDI与50％官能度大于2以上的多异氰酸酯组成的混合物。升温时能发生自聚作用。溶于氯苯、邻二氯苯、甲苯等。PAPI的活性低，蒸气压低，只是TDI的百分之一，故毒性很低。
用于制造聚氨脂胶粘剂。也可直接加入橡胶胶粘剂中，改善橡胶与尼龙或聚酯线的粘接性能。贮存于阴凉、通风、干燥的库房内，远离火种、热源。严格防水、防潮，避免光照。
用于制造聚氨脂胶粘剂。也可直接加入橡胶胶粘剂中，改善橡胶与尼龙或聚酯线的粘接性能。贮存于阴凉、通风、干燥的库房内，远离火种、热源。严格防水、防潮，避免光照。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条