1) infusing with negative pressure filtration
负压抽滤注浆
1.
Hydroxylapatite(HA) interconnected hollow spheral ceramic was fabricated by the infusing with negative pressure filtration using the polystyrene microspheres.
利用聚苯乙烯微球模板,采用负压抽滤注浆工艺制备了羟基磷灰石(hydroxylapatite,HA)内连通空心球陶瓷支架,分析了制备工艺对空心球陶瓷的形貌特征和力学性能的影响,并研究了孔隙率与压缩强度的关系。
2) pumping grouting
抽水注浆
1.
Combined with the continuous concrete box beam construction in Haizigou bridge work as example the pumping grouting method of vertical prestressed duct of reinforcement are analyzed from four aspects: drilling, intubation, pumping and grouting; at the same time corresponding resolving measures are proposed.
结合海子沟大桥四跨连续混凝土箱型梁施工工程 ,就其竖向预应力钢筋孔道的抽水注浆方法 ,从打孔、插管、抽水、灌浆四方面进行了分析 ,提出了相应的处理方
3) negative pressure of suction
抽放负压
4) suction pressure of the drainage system
抽采负压
5) lymphosuction
负压抽吸
1.
Treatment for chronic limb lymphedema by lymphosuction;
负压抽吸治疗肢体淋巴水肿
6) glucose transportation
抽吸负压
1.
Methods We harvested two groups (ⅠandⅡ) of fat with machine (usually 70~80kPa) and 60ml syringe (26~40kPa) jointing same diameter but different distal opening cannulas, made them suffered glucose transportation test which was as follows putting two groups of fats into DMEM containing glucose to incubate for 1 hour and then detecting the change of glucos.
目的:探讨抽吸负压对所抽吸脂肪颗粒活性的影响,明确脂肪移植术中是否可用吸脂机获取脂肪。
补充资料：电泳注浆成型
分子式：
CAS号：
性质：陶瓷浆料的成型方法之一。利用浆料中颗粒荷负电，在直流电场作用下向阳极运动而沉积在模型(阳极)上形成坯体的成型方法。此法可加快坯体形成速度，坯体较致密，可用于面砖，基板等的成型，但有时会因水的电解作用产生气泡，电场不均匀会造成坯体厚薄不均或脱模困难，故尚未得到广泛使用。
CAS号：
性质：陶瓷浆料的成型方法之一。利用浆料中颗粒荷负电，在直流电场作用下向阳极运动而沉积在模型(阳极)上形成坯体的成型方法。此法可加快坯体形成速度，坯体较致密，可用于面砖，基板等的成型，但有时会因水的电解作用产生气泡，电场不均匀会造成坯体厚薄不均或脱模困难，故尚未得到广泛使用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条