说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 旋变信号发生
1)  generating follow up signal
旋变信号发生
2)  Frequency conversion s
变频信号发生器
3)  rotary pressure signal generator
旋转压力信号发生器
1.
Firstly the role of the rotary pressure signal generator is introduced in the system of wireless MWD,and based on the principle of the rotary pressure signal generator,a system structure models are designed,according to the different stages of the process,various process valves mouth dynamic equation is established.
介绍了压力信号发生器在无线随钻测量系统中的作用,以旋转压力信号发生器的基本工作原理为基础,设计了系统的结构模型,根据系统在工作过程中不同阶段的特点,建立了各个过程中的阀口动态方程;以转速和开度为控制输入,进行了实例仿真。
4)  VVVF signal generator
变压变频信号发生器
5)  signal generating
信号发生
1.
The structure,function and features of a virtual signal generating and acquiring system,which is designed by graph programming language-LabVIEW are introduced.
介绍了利用LabVIEW图形编程语言开发的虚拟信号发生和采集系统的结构、功能和特点。
2.
Finally,the methods of design of signal generating task as the case of signal generating function is given.
详细论述了仪器的硬件组成和设计,简要说明了移植μClinux嵌入式操作系统的关键和对操作系统的扩展设计,最后以信号发生功能部分为例给出了信号发生器的设计方法。
3.
Considered the problem of inconvenient circumstances of engineering and technical personnel s being measuring signals and analyzing data outdoors, especially field work, the instrument with the functions of signal sampling, spectrum analysis, signal generating, is designed.
便携式智能仪器是在考虑到科研人员在室外、尤其是野外,测量分析条件不便的问题,而设计的具有信号采集、频谱分析、信号发生功能的低功耗、多用途的仪器设备。
6)  Signal generation
信号发生
1.
Application of the MAX038 and single chip in the signal generation and frequency measurement;
MAX038和单片机在信号发生与频率测量中的应用
补充资料:非正弦波信号发生器


非正弦波信号发生器
nonsinusoidal signal generator

  充电状态。如此周而复始。Uc为三角形波,U。为矩形波。可按电容充放电的公式得矩形波的周期T一_~~,f_.ZR:}_~、二一,、一Z找七m}1十二厂},犯形淡阴狈华 \八f/F一喜一1__ 1_一一、{_艺式1) 艺找七上n}1十二于} \八f/ .、_~_,一__.,Rl____,一.一一,田上式叫见:改尖八、C飘才即叫改堂狈华。田 1、£图1(b)可知:改变U;值,即可改变矩形波的幅值。此外,由于电容C的充放电时间常数均为RC,故矩形波的占空比D一丝;票旦一。.:。目J目一~一T一’”“ 丑Rl+Rr肠Vz┌───┐│ )c匕││ N+ ││+ │└───┘ 左,一,布尸-了二尸Uz人l十式f士U: ┌──┬─┐ │ │ │┌─┼──┼─┤│ │tI │f2│├─┼──┼─┘│ │T/2 │ │ ├──┤ │ │ │ └─┴──┘ 图1矩形波信号发生器 (a)电路图;(b)波形图 锯齿波信号发生器电路如图2(a)所示。图中由运算放大器、稳压管和电阻R。、R、、R:组成带正反馈的迟滞型比较器,由结型场效应管和电容C构成反,~_,。、______.__R、__._二_、.、馈网络。当U。一U:时,U。一不拜~下U:,结型场效应~’翎一曰“一一“一一书’一”Rl+R,一乙’~~~~~管的漏极d处于正电位,工作在恒流源状态,它以恒定电流向C充电,使输出电压U。(~UC)直线上升,如图2(b)所示。“UcI升到Uc一二饭海瓦U:时,比较器发生跳变,其输出电压U乙由+U:跳变到一Uz,使Up一彩筑U:。这时漏极d处于负电位,源极s处于正电位,结型场效应管处于倒向工作状态,即d起源极作用,S极起漏极作用,栅极电压为正值,PN结正偏,sd间呈低阻状态,使电容C放电加速。所以,电┌──────┐│-一一节一 │└──────┘ ┌────┐ │ 卜。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条