1.
Study on Hot Workability of CuNiMnSi Alloy
CuNiMnSi合金的热加工性能研究
2.
Study on the Influence of Residual Copper in Steel to the Hot-working Performance of Steel
钢中残余铜元素对钢热加工性能的影响研究
3.
Harmfulness of Residual Cu to Hot-working Properties of Steel and Its Suppression Measures
残余Cu对钢材热加工性能的危害及其抑制措施
4.
A study of mechanical properties and hot working process of SiC_P/FVS0812 composite
SiC_P/FVS0812的热加工工艺及力学性能研究
5.
Performance of thermoset rubber but processed like thermoplastic.
热固性橡胶之性能，热塑性塑料之加工方法 .
6.
The Studies on the Processing, Microstructures and Properties of Thermoplastic Starch;
热塑性淀粉塑料加工、结构和性能研究
7.
Milling Property of Ferrite F92 Heat-resistant Steel
新型F92铁素体耐热钢的铣削加工性能
8.
Property requirement and production process of hot-dip galvanizing steel wire for bridge cables
桥梁缆索用热镀锌钢丝的性能要求与加工工艺
9.
Effect of Cold Deformation and Heat Treatment on Microstructure and Mechanical Properties of the TM50 Titanium Alloy;
冷加工及热处理对TM50钛合金组织与性能的影响
10.
An Analysis of the Thermal Performance of Autoclaved Aerated Concrete Blocks
蒸压加气混凝土砌块的热工性能与分析
11.
Sodium silicate sand hardened by twice microwave heating and its performance characteristic
二次微波加热水玻璃砂工艺及性能特征
12.
Study on Processing and Mechanical Properties of PVC Rare-Earth Compound Stabilizer System
PVC复合稀土热稳定体系加工与应用性能
13.
Effect of Hot Stamping on Flexural Fatigue Property of QSS400 Axle Housing Steel
热冲压加工对QSS400桥壳钢弯曲疲劳性能的影响
14.
Effect of Heat Treatment on Microstructure and Mechanical Properties of Ti53311s Titanium Alloy
热加工对Ti53311s钛合金显微组织和力学性能的影响
15.
Workability and Processing Map of SiC Particle Reinforced Aluminum Matrix Composites at High Temperature and Strain Rate
SiC颗粒增强铝基复合材料的热成形性能与热加工图
16.
Heating performance of a jetting-mixing low-pressure heater
引射混合式低压加热器加热性能试验
17.
Investigation of Hot Processing, Microstructure and Properties of Spray Deposition SiC_p/Al-Fe-V-Si Composite;
喷射沉积SiC_p/Al-Fe-V-Si复合材料热加工工艺、组织及性能的研究
18.
Effects of Hot Working on the Microstructure and Mechanical Properties of Spray-deposited SiC_P/Al-Fe-V-Si Composites
热加工工艺对喷射沉积SiC_p/Al-Fe-V-Si组织与性能的影响