1.
Research on Pressure Rules in Tinning Plate Tandem Cold Mill Process
镀锡板冷连轧过程中压下规程优化技术研究
2.
It is showed from the actual examples that the plate shape can be the best with optimizing the press rules to make the shape ratio for every pass equaled.
通过实际算例,优化压下规程可使各道次的板型系数相等,表明板型达到最佳状态。
3.
Optimization of Pressure Vessel Engineering ?
压力容器工程优化(2)
4.
Research on Wrinkling and Parameter Optimization of Strip Metal In-Plane Bending under Unequal Compressing;
板带不均匀压下面内弯曲过程失稳起皱与参数优化的研究
5.
Research on Optimal Method for Two-Period Suppyier Production Planning Based on Process Industries Implemented Mass Customization;
流程工业大规模定制条件下两阶段供应商生产计划优化方法研究
6.
Optimization of Low Voltage Power Network Base on GIS;
基于GIS的低压电网优化规划研究
7.
Simulation analysis of upper rolling schedule of roll-type straightener
辊式矫直机上辊压下规程的仿真分析
8.
Optimal Allocation of Sectionalizing Switchs and Loop Switchs for the Voltage-time Type Feeder Automation System of Distribution Networks;
配电网电压—时间馈线自动化配电开关优化规划
9.
Development of Optimization Engineering Software for Transformer Core Section
变压器铁心截面优化工程软件的开发
10.
The Process Simulation and Heat Exchanger Network Optimization of Atmosphere-Vacuum Distillation Process;
常减压装置过程模拟与换热网络优化
11.
Experimentation optimization of technological parameters of extrusion die in the continuous extrusion process
连续挤压过程中模具寿命的优化研究
12.
Flow optimization of an atmospheric distillation unit based on aspen plus
基于Aspen Plus的常压蒸馏装置流程优化
13.
Aerodynamic optimization research for contour of ramjet assisted projectile inlet
冲压增程弹进气道型面气动优化研究
14.
Optimal Design on RZU2400 Hydraulic Press Lower Beam;
RZU2400型液压机下横梁结构优化设计
15.
The Optimization on Techniques of φ800 Rolling Mills and Automatical Depress Controlling;
φ800轧机工艺优化及自动压下控制
16.
Simultaneous Topology and Shape Optimization of Pressure Loaded Structures
压力载荷下的结构拓扑-形状协同优化
17.
Optimal Design of a Cylinder under Uniform Lateral Pressures
均匀侧压作用下圆柱体优化设计问题
18.
Development of the Calculation and Optimization System on Cold Continuous Rolling Regulation Design;
冷连轧规程设计计算与优化系统开发